Loading ...
Loading ...
Loading ...
10
Installation (continued)
A
A
AA
3
Installing the Side Curtains
□ Place cabinet on the floor, a bench, or a table.
□ Slide"Ⅰ"section at the end of side curtain (DD) into side
rail (GG) on each side of the cabinet.
□ On each side of cabinet, insert the curtain housing (A)
into channel in the top rail (FF) and bottom rail (B).
A
DD
FF
GG
B
□ Shift cabinet left or right as needed to line up center of
cabinet on center line marked on inner sill.
□ For wooden window: Fasten cabinet to window inner sill with
two 3/4 inch screws (LL) into holes (you may wish to pre-drill
pilot holes).
3/4 inch
screw (LL)
LL
II
□ For Vinyl-Clad window: Place two safety locks (II) into the holes
located in the bottom of the cabinet and drive two 3/4 inch
screws (LL) through the safety locks into the cabinet as shown.
QQ
MARK
MARK
5
Install Support Bracket
□ Hold each support bracket (QQ) flush against outside of sill and
tight to bottom of cabinet. Mark brackets at top level of sill.
Mark cabinet bottom at distance of sill width. Remove support
brackets.
BB
□
Remove protective strip from adhesive side of the adhesive
Seal (narrow) (BB). Apply Seal over screws fastening bottom
rail to window inner sill.
4
Place Cabinet in Window
□
Open the window and mark the center of window inner sill
as shown.
□
Cut the adhesive seal (wide) (AA) to the width of the lower
window
sash (A). Remove the backing from the seal and
attach the
seal to the bottom of the lower window sash.
□ Place cabinet in window with bottom rail securely seated
over the edge of inner sill as shown. Bring window down
temporarily behind top rail to hold cabinet in place.
Bottom rail
Window inner
sill
Window outer sill
Bottom rail securely seated
over the edge of inner sill
Loading ...
Loading ...
Loading ...