Loading ...
Loading ...
Loading ...
WARNING!
Raising the vehicle higher than necessary can
make the vehicle less stable. It could slip off the
jack and hurt someone near it. Raise the vehicle
only enough to remove the tire.
5. Remove the wheel lug nuts, for vehicles with
wheel covers, remove the cover from the
wheel by hand. Do not pry the wheel cover off.
Then pull the wheel off the hub.
6. Install the inflatable spare on the vehicle,
located in the rear cargo area of the vehicle.
WARNING!
To avoid the risk of forcing the vehicle off the
jack, do not tighten the wheel nuts fully until
the vehicle has been lowered. Failure to follow
this warning may result in serious injury.
CAUTION!
Be sure to mount the inflatable spare tire with
the valve stem facing outward. The vehicle
could be damaged if the inflatable spare tire is
mounted incorrectly.
NOTE:
Do not install the wheel cover on the inflat-
able spare tire.
7. Leave the vehicle on the jack and start inflat-
ing the inflatable spare after the tire has been
mounted to the vehicle. Secure the wheel to
the hub by tightening the nuts with the
wrench. After inflation, once the vehicle is
lowered you will have a second opportunity to
“torque” the lug nuts.
8. Inflate the tire to the prescribed pressure
60 psi (4.2 Bar) using the Portable Air
Compressor or Tire Service Kit if equipped.
9. Lower the vehicle once the inflatable Spare
has reached its pressure and the compressor-
hose has been removed from the tire valve.
10. Finish tightening the lug nuts. Push down on
the wrench while at the end of the handle for
increased leverage. Tighten the lug nuts in a
star pattern until each nut has been tightened
twice. If in doubt about the correct tightness,
have them checked with a torque wrench by
an authorized dealer or at a service station.
TIRE SERVICE KIT —
IF EQUIPPED
Use this QR code to access your
digital experience.
Your vehicle may be equipped with
a Tire Service Kit. Small punctures
up to 1/4 inch (6 mm) in the tire
tread can be sealed with Tire Ser-
vice Kit. Foreign objects (e.g., screws or nails)
should not be removed from the tire. Tire Service
Kit can be used in outside temperatures down to
approximately -4°F (-20°C). This kit will provide
a temporary tire seal, allowing you to drive your
vehicle up to 100 miles (160 km) with a maximum
speed of 50 mph (80 km/h).
If a tire is punctured, you can make an emer-
gency repair using the Tire Service Kit.
The Tire Service Kit includes:
•
Sealant/Air Hose.
•
Hose Accessories.
•
Mode Select Knob.
•
Pressure Gauge.
•
Deflation Button.
•
Power Switch.
•
Sealant Bottle.
•
Power Plug.
Scan me
EMERGENCY 35
Loading ...
Loading ...
Loading ...