Loading ...
Loading ...
Loading ...
6
Place the stainless steel filter basket on top of the recollecting ring tray until it fits the
grooves of the motor shaft.
Place the clear cover on top of the recollecting ring tray and stainless steel filter
basket. Adjust it until it aligns properly. Place the food pusher into the clear cover
guiding the tab through the groove on the clear cover.
Raise the handle (clamp) and place it on the grooves of the locking tabs located on
the clear cover. Push to lock it. The juice extractor will not operate unless the handle
and lid are properly locked.
Place the pulp collector container by tilting it slightly and sliding it under the clear
cover.
Place the juicer container under the spout located on the right hand side of the
motor base. Tilt it slightly and slide it into place. The froth separator will allow to
serve juice without the foam and the foam caused during juice extraction will remain
inside the container.
OPERATING INSTRUCTIONS
Make sure your juice extractor is properly assembled. Please follow the instructions
from the section “Before using the juice extractor.” The Button switch must be in the
“O” (OFF) position. This juice extractor has a safety device. If the handle (clamp) is
not fasten appropriately, the motor will not turn on. This is a safety feature that will
ensure the unit will not operate unless the lid is properly locked.
Prepare your fruits and vegetables by washing them thoroughly and peeling off
those that need the skin removed. Remove any stones, pits or cores to prevent
damage to the appliance.
Ensure the juice extractor and its accessories are clean by following the cleaning
and maintenance section of this manual.
Place the juicer container under the spout and make sure the pulp collector
container is installed before beginning juicing. Do not allow the pulp collector
container to overfill as this may cause the unit to stall.
Plug the power cord into an electrical outlet and turn the power on “I.” Let the motor
run without load for about 10 seconds.
Once the juicer is on, place the fruits and vegetables on the food chute and use the
food pusher slowly to drive them down. In order to extract the maximum amount
of juice, it is important to push the food pusher slowly. If you press too hard or
too fast, the juicing effect will be reduced.
The slow juicing setting “I” is suitable for soft, juicy fruits or vegetables such as
cantaloupes (peeled), tomatoes etc.
Loading ...
Loading ...
Loading ...