Loading ...
Loading ...
Loading ...
12
Model No. Description
Dremel chuck
compatible? Comment
220 Workstation drill press Yes
225 Flex Shaft Yes
Chuck fits on the
output shaft of the
Flex Shaft
335-01 Plunge Router No Collet is required
A550 Shield Yes
565 Multipurpose cutting kit No Collet is required
575 Right angle attachment Yes
Chuck fits on the
output shaft of the
right angle
attachment
670 Mini Saw attachment N/A
A679-02 Sharpening kit No Collet is required
231 Router Table No Collet is required
A576 Sanding/Grinding Guide No Collet is required
490 Dust Blower No Collet is required
577 Detailers Grip Yes
678-01 Circle cutter / straight edge guide No Collet is required
BALANCING ACCESSORIES
For precision work, it is important that all
accessories be in good balance (much the
same as the tires on your automobile). To true
up or balance an accessory, slightly loosen
chuck or collet nut and give the accessory or
collet a 1/4 turn. Re tighten the chuck or collet
nut and run the Rotary Tool. You should be able
to tell by the sound and feel if your accessory is
running in balance. Continue adjusting in this
fashion until best balance is achieved. To
maintain balance on abrasive wheel points,
before each use, with the wheel point secured
in the collet, turn on the Rotary Tool and run the
415 Dressing Stone lightly against the revolving
wheel point. This removes high spots and trues
up the wheel point for good balance.
4300 Attachment Compatibility
Dremel rotary tool attachments allow you to
change the function of your tool so that it is
more optimized for your application. You can
find the full line of Dremel rotary tool
attachments on Dremel.com. The Dremel
4300 is compatible with all currently available
Dremel attachments. Depending on the
attachment being used, you will either need to
use a collet and collet nut to hold the accessory
or will be able to use the Dremel Chuck to hold
the accessory. The following chart shows
which attachments function with the Dremel
Chuck. For more information on individual
attachments, please refer to the user manual
for those attachments in this manual or that
came with those attachments.
Do not use router bit with the Dremel chuck. Bit may become a projectile
and cause serious injury.
1600A012FN.qxp_4300 1/30/17 10:06 AM Page 12
Loading ...
Loading ...
Loading ...