Loading ...
Loading ...
Loading ...
30 INSTALLATION
inch (1.5 cm). The dryer should be checked while
the dryer is running with no load.
Checking Levelness
Once the dryer is in its final location, recheck the
dryer to be sure it is level. Make sure it is level front
to back and side to side, and that all four leveling
feet are in firm contact with the floor.
Test Exhaust System
Once you have completed the installation of the
appliance, use this test to make sure the condition
of the exhaust system is adequate for proper
operation of the appliance. This test should be
performed to alert you to any serious problems in
the exhaust system of your home.
•Your appliance features Flow Sense
TM
, an
innovative sensing system that automatically
detects blockages and restrictions in dryer
ductwork. Keeping ductwork clean of lint
buildup and free of restrictions allows clothes to
dry faster and reduces energy use.
NOTE
• The appliance should be cool before starting this
test. If the appliance was warmed up during
installation, run the Air Dry cycle for a few
minutes to reduce the interior temperature.
Activating the Installation Test
1 Remove the drying rack and literature, and
then close the door.
• Do not load anything in the drum for this
test, as it may affect the accuracy of the
results.
2 Press and hold the Signal and Temp. buttons
and then press the Power button. (DL*X3****
/ DL*X4**** / DL*350** / DL*346**)
Press and hold the Energy Saver and Temp.
buttons and then press the Power button.
(DL*360**)
Press and hold the Wrinkle Care and Temp.
buttons and then press the Power button.
(DL*340**)
• On models with a glass touch control panel,
press the Power button then IMMEDIATELY
press and hold the other 2 buttons.
• This button sequence activates the
installation test. The code
1Ns or 1N will
display if the activation is successful.
3 Press the Start/Pause button.
• The appliance will start the test, which will
last a few minutes. The heat will be turned
on and the temperatures in the drum will be
measured.
4 Check the display for results.
• During the test cycle, monitor the Flow
Sense
TM
display on the control panel. If the
Flow Sense
TM
LED has not turned on when
the cycle ends, the exhaust system is
adequate. If the exhaust system is severely
restricted, the Flow Sense
TM
LED will turn
on. Other problems may also be shown with
error codes. See the chart on the next page
for error code details and solutions.
•If the Flow Sense
TM
LED indicates that the
exhaust system is severely restricted, have
Loading ...
Loading ...
Loading ...