Loading ...
Loading ...
Loading ...
INSTALLATION MANUAL
INSTALLATION
12
RECIRCULATION
COVER PLATE
SCREWS
NON-DUCTED INSTALLATION ONLY
7 ] Remove 3 screws retaining the recirculation cover plate to the hood. Discard this plate
with its screws. Peel off and discard the membrane covering the recirculation grille,
ensuring the openings are totally cleared.
3¼” x 14” DUCTED INSTALLATION ONLY
TIP: Insert a small length of duct over the 3¼” x 14” damper assembly and seal the joint using
aluminum foil duct tape to ease connection with the house ductwork.
8 ] Remove 3¼” x 14” vertical or 3¼” x 14” horizontal knockout plate as appropriate for
your ducting method (see FIGURES 1 A and 1 B).
3¼” X 14”
VERTICAL
KNOCKOUT
PLATE
3¼” X 14”
HORIZONTAL
KNOCKOUT
PLATE
FIGURE 1 A
3¼” X 14”
DAMPER
ASSEMBLY
TOP/BACK
EDGE OF
HOOD
DAMPER
FLAP
PIVOT
SCREWS
FIGURE 2 A FIGURE 2 B
9 ] Assemble the 3¼” x 14” frame (removed in step 2) with the damper flap (removed in step 4)
by following the instructions provided on a separate sheet. Attach the 3¼” x 14” Damper
Assembly on top OR back of hood over the knockout opening using the screws removed in
step 2. When installed, the 3¼” x 14” damper assembly must open as shown in FIGURE 2 B.
FIGURE 1 B
3¼” X 14”
DAMPER
ASSEMBLY
BACK OF
HOOD
DAMPER
FLAP
PIVOT
SCREWS
Loading ...
Loading ...
Loading ...