Loading ...
Loading ...
Loading ...
ROUGH-IN DIMENSIONS
17 17
(43.2)
¾¾ --
SIDE
Cord
331/2
IMPORTANT
MINIMUM INSTALLATIONCLEARANCES
When installed in alcove:Sides,Rear,Top= 0 in
(0 cry]).
When installed in closet: Sides,Rear,Top= 0 in
(0 cm), Front = 1in (2.54 cm).
Closet door ventilation openings required: 2 louvers each60 in2
(387 cm2)- 3 in (7.6 cry])from top and bottom of door.
UNPACKING
1. Cut the shipping carton along the dotted line along the base of
the unit.
2. While in the carton carefully lay the washer ors its back side.
3. Remove the styrofoam base.
4. Carefully return thewasher to an upright position and remove
the carton.
5. Carefully move the washer to within 4 feet (122cm) of the
final location.
6. Remove the following
from the back side
of the washer;
3 bolts,
3 yellow
plastic spacers,
2 or 3 metal
"P" clamps,
inch (cm) Adjustable L_s
43/8
(I 1.2)
t.>
36
[91.5)
Counter
%
S
Y Y
2%
(7.3)
A
Inlets
(so.3)
LOCATION OF YOUR WASHER
DO NOT INSTALL YOUR WASHER:
1. In an area expose(] to dripping water or outside weather conditions. The ambient
temperature should never be below 60 degrees F (15.6 degrees C) for proper
washer operation.
2. In an area where it will come in contact with curtains or drapes.
3. In an area (garage or garage-type building) where gasoline of other flammables are
kept or stored (including automobiles).
4. On carpet. Floor MUSTbe solid with a maximum slope of 1/2 in. per foot (I .27 cm
per 30.5 cm). To ensure vibration or movement does not occur, reinforcement of
the floor may be necessary. 4
(_) BOLT
SPACER
(_) CLAMP
7. Remove the service panel from the front of the washer.
8. Remove the 4 nuts and 6 large washers that attach the 2
yellow shipping braces to the drum and the base. Lift up on
the drum and remove the braces (a yellow ribbon surrounds
the items to be removed). These braces must be removed to
allow the power supply cord to be released from the shipping
ring.
9. Remove the large styrofoam block
located under the drum. Lift up
ors the drum, tilt the base of
the foam block inwards
toward the rear of the
washer until free, then
pull it out.
10. Remove and discard
the yellow ribbon
and label from
the front of the
washer.
@
11. From the rear of the washer, carefully pull out the power
supply cord through the hole in the backsheet.
12.Replace the service panel and screws.
NOTE: If the washer is to be transported at a later
date, the shipping support hardware must be
reinstalled to prevent shipping damage.
Loading ...
Loading ...
Loading ...