Loading ...
Loading ...
Loading ...
ASSEMBLY- BASE & MIDSECTION
ASSEMBLY- HANDLE
1. VACUUM ASSEMBLY
5
G
CARTON CONTENTS
1.1
E
UPPER HANDLE
UPPER
CORD
HOOK
CORD
MIDSECTION
TABS
BASE
1.3 Slide upper handle down
onto unit. Place nut into
recess in back of upper
handle. While holding nut in
place, insert screw through
front of upper handle and
tighten. Route cord above
upper cord hook and snap
into cord clip on upper
handle.
1. CLEANER ASSEMBLY
A. Handle
B. Cleaner Base
C. Midsection
D. Dirty Water Tank
E. Clean Water Solution Tank
F. Screws (4)
G. Nuts (4)
Remove all parts from carton and identify each item
shown.
Make sure all parts are located before disposing of
packing materials.
5
A
B
C
F
Using a Phillips screwdriver
1.2 Stand base in upright position. Push midsection onto
base by aligning tabs on the backside of midsection with
the pockets on the backside of base.
One at a time, place nut into recess located on the back of
the left, right and middle back of the base. While holding
nut in place, insert screw through front of midsection and
tighten.
Repeat this process with the remaining two (2) nuts and
screws
CARTON CONTENTS
1.1
1.2
1.3
D
• NOTICE •
Make sure the power cord is out of the way to
avoid pinching.
Loading ...
Loading ...
Loading ...