Loading ...
Loading ...
Loading ...
1
2
3
This is a diagnostic charger. The Charger LED Light (3)
illuminates in a specified order to show the current battery
status. They are as follows:
CHARGING PROCEDURE (LED INDICATOR)
BATTERY IS CHARGING
GREEN
BLINKING
FULLY CHARGED
GREEN
BATTERY IS TOO WARM (RE-
MOVE FOR APPROX. 30 MINUTES
TO ALLOW TO COOL)
RED
DEFECTIVE BATTERY (REMOVE
AND REPLACE WITH A NEW BAT-
TERY)
RED
BLINKING
Incorrect Defect Note:
1. Put the battery pack into the charger.
• If the status LED1 flashes red and LED2 flashes
green, remove the battery pack from the charger for 1
minute.
2. Put the battery pack into the charger again.
• If the status LEDs show correct, the battery pack is
good.
• If the status LED1 and LED2 stay blinking, remove
the battery pack and disconnect the charger.
3. Wait for 1 minute and put the battery pack into the
charger again.
• If the status LEDs show correct, the battery pack is
good.
• If the statusLED1 and LED2 stay blinking, the
battery pack is defective and it is necessary to replace
the battery pack.
6.2 EXAMINE THE CHARGER
If the battery pack does not charge correctly:
1. Examine the current of the power outlet with different
machines. Make sure that the outlet works.
2. Examine that the charger contacts are not short-circuited.
3. If the charger is not under usual room temperature, move
the charger and battery pack to a location where the
temperature is between 6 ˚C and 40˚C .
WARNING
If you put the battery pack into the charger in warm or hot
environment, the charger LED light is red. Pull out the
battery pack and let the battery cool for approximately 30
minutes.
6.3 MOUNT THE CHARGER
1. Get the location of the wall to attach the charger.
2. Use 2 wood screws to attach the charger on the wood
studs.
3. For charger 29482: Drill two paralleled holes 2 3/8” (60
mm) on center. For charger CAF806: Drill two paralleled
holes 5” (127 mm)on center.
4. Use wall anchors and screws to attach the charger to the
drywall.
For charger 29482:
For charger CAF806:
NOTE
If you do not use the battery pack and charger for a long
time, please remove the battery from the charger and pull
out the AC power plug.
6
English
EN
Loading ...
Loading ...
Loading ...