Loading ...
Loading ...
Loading ...
[] KEEPBiTSCLEANANDSHARP.Sharpbitsminimize
stalling.Dirtyanddullbitsmaycausemisalignmentof
thematerialandpossibleoperatorinjury.
[] KEEPHANDSAWAYFROMWORKAREA.Keep
handsawayfromthebit.Restrainanylooseclothing,
jewelry,longhair,etc.,thatmaybecomeentangledin
thebit.
[] ALWAYSCLAMPWORKPIECEANDBRACE
AGAINSTCOLUMNTOPREVENTROTATION.Never
useyourhandtoholdtheobjectwhiledrilling.
[] USE RECOMMENDED SPEED FOR DRILL
ACCESSORY AND WORKPIECE MATERIAL.
[] BE SURE DRILL BiT OR CUTTING TOOL iS
SECURELY LOCKED iN THE CHUCK,
[] BE SURE CHUCK KEY iS REMOVED from the chuck
before connecting to power source or turning power
ON.
[] ADJUST THE TABLE OR DEPTH STOP TO AVOID
DRiLLiNG iNTO THE TABLE. Shut off the power,
remove the drill bit, and clean the table before leaving
machine.
[] ALWAYS ENSURE THE LASER BEAM iS AIMED AT
A SURFACE WITHOUT REFLECTIVE PROPERTIES.
Shiny reflective materials are not suitable for laser use.
[] AVOID DIRECT EYE EXPOSURE when using the laser
guide.
[] NEVER PLACE YOUR FINGERS iN A POSiTiON
WHERE THEY COULD CONTACT THE DRILL or
other cutting tool if the workpiece should unexpectedly
shift.
[] NEVER PERFORM ANY OPERATION by moving the
head or table with respect to one another. Do not turn
the motor switch ON or start any operation before
checking that the head and table support lock handle
is clamped tight to column and head and table support
collars are correctly positioned.
[] BEFORE ENGAGING THE POWER SWITCH, MAKE
SURE THE BELT GUARD iS DOWN AND THE
CHUCK iS iNSTALLED PROPERLY.
[] LOCK THE MOTOR SWITCH OFF WHEN LEAVING
THE DRILL PRESS. Do not perform layout, assembly,
or set-up work on the table while the cutting tool is
rotating, switched on, or connected to a power source.
[] iF THE POWER SUPPLY CORD iS DAMAGED, it
must be replaced only by the manufacturer or by an
authorized service center to avoid risk.
[] SAVE THESE iNSTRUCTiONS. Refer to them fre-
quently and use to instruct other users. If you loan
someone this tool, loan them these instructions also.
_ WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities
contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
• lead from lead-based paints,
crystalline silica from bricks and cement and other masonry products, and
arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure
to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust
masks that are specially designed to filter out microscopic particles.
Loading ...
Loading ...
Loading ...