Loading ...
Loading ...
Loading ...
iNSTALLINGTABLEASSEMBLY
See Figures 6 - 8.
[] Loosen the set screw in the column collar. Remove the
column collar and gear rack from the column and set
aside.
[] Locate the worm gear and feed the D-shaft through the
slot in the table support.
[] Install table adjustment handle over the end of the
D-shaft so that the flat side of the shaft aligns with the
set screw. Tighten the set screw using the hex key.
[] Feed the gear rack through the slot in the table as-
sembly so that the teeth are facing out and the longer
smooth end faces up. The worm gear should engage
the gear rack.
[] Using both hands, slide the entire table assembly and
gear rack onto the column until the bottom of the gear
rack is positioned in the base collar and against the
column.
[] Slide the column collar, bevel-side down, over the col-
umn until the beveled side engages the beveled end of
the gear rack. Tighten the set screw in the collar using
the hex key. Do not overtighten.
NOTE: You should be able to move the table from side
to side.
[] Locate the table lock handle. Insert it into the threaded
hole at the rear of the table assembly and tighten by
hand.
SLOT
TABLEASSEMBLY
Fig. 6
COLUMN
COLLAR__--_1 _ SET
i SCREWS
D
TABLE
ADJUSTMENT
HANDLE
GEAR
RACK
Fig. 7
TABLE
•-._. LOCK
HANDLE
THREADED
HOLE
/
Fig. 8
14
Loading ...
Loading ...
Loading ...