Karcher 1.109-101.0 STP Shark Series High Pressure Cleaner

Operating instructions - Page 5

For 1.109-101.0. Series: Shark Series
Also, The document are for others Karcher models: STP-231007D, 1.109-102.0, STP-201507D, 1.109-103.0, STP-352007A, 1.575-513.0, STP-231007D, 1.109-133.0, STP-231007D, 1.109-134.0

PDF File Manual, 31 pages, Read Online | Download pdf file

Loading ...
Loading ...
Loading ...
Manual Karcher STP 9.801-191.0 - D
5
PRESSURE WASHER
OPERATOR’S MANUAL
13. Never make adjustments on machine while in op-
eration.
14. Be certain all quick coupler fittings are secured
before using pressure washer.
RISK OF INJECTION
OR SEVERE INJURY
TO PERSONS. KEEP
CLEAR OF NOZZLE.
WARNING
WARNING: High pressure devel-
oped by these machines will
cause personal injury or equip-
ment damage. Keep clear of
nozzle. Use caution when oper-
ating. Do not direct discharge
stream at people, or severe in-
jury or death will result.
WARNING
PROTECT FROM
FREEZING
WARNING: Protect machine from
freezing.
15. To keep machine in best
operating conditions, it is
important you protect machine
from freezing. Failure to protect
machine from freezing
could cause malfunction of the
machine and result in death,
serious bodily injury, and/or property damage. Fol-
low storage instructions specified in this manual.
16. Inlet water must be clean fresh water and no hotter
then 90°F.
RISK OF
ASPHYXIATION: USE
THIS PRODUCT ONLY
IN A WELL
VENTILATED AREA.
WARNING: Risk of asphyxiation.
Use this product only in a
well ventilated area.
17. Avoid installing machines in
small areas or near exhaust
fans. Adequate oxygen is need-
ed for combustion or dangerous
carbon monoxide will result.
18. Manufacturer will not be
liable for any changes made
to our standard machines or any components not
purchased from us.
19. The best insurance against an accident is precau-
tion and knowledge of the machine.
WARNING
RISK OF INJURY FROM
FALLS WHEN USING
LADDER.
WARNING: Be extremely careful
when using a ladder, scaffolding
or any other relatively unstable
location. The cleaning area
should have adequate slopes
and drainage to reduce the pos-
sibility of a fall due to slippery
surfaces.
20. Do not overreach or stand on unstable support.
Keep good footing and balance at all times.
IMPORTANT SAFETY INFORMATION
21. Do not operate this machine when fatigued or under
the influence of alcohol, prescription medications,
or drugs.
WARNING
DO NOT SPRAY
MACHINE OR ANY
PEOPLE, ANIMALS OR
ELECTRICAL PARTS.
WARNING: Do not spray machine
or any people, animals or electri-
cal parts.
AVERTISSEMENT:
Ne pas va-
poriser sur la machine ou les
gens, les animaux ou les pi
èces
électriques.
Follow the maintenance instructions
specified in the manual.
INSTALLATION
Place machine in a convenient location providing ample
support, draining and room for maintenance.
This machine is intended for indoor use. Machine
must be stored indoors when not in use.
Location:
The location should protect the machine from damag-
ing environmental conditions, such as wind, rain, and
freezing.
1. This machine should be run on a level surface
where it is not readily influenced by outside
sources such as strong winds, freezing tem-
perature, rain, etc. It should be located to allow
accessibility for refilling of fuel, adjustments, and
maintenance. Normal precautions should be
taken by the operator of the machine to prevent
moisture from reaching the electrical controls.
2. It is recommended that a partition be made
between the wash area and the machine to pre-
vent water spray from coming in contact with the
machine. Excess moisture reaching any electric
components or electrical controls will reduce
machine life and may cause electrical shorts.
3. During installation of the machine, beware of
poorly ventilated locations or areas where ex-
haust fans may cause an insufficient supply of
oxygen. Sufficient combustion can only be ob-
tained when there is a sufficient supply of oxygen
available for the amount of fuel being burned. If
it is necessary to install a machine in a poorly
ventilated area, outside fresh air may have to be
piped to the burner and a fan installed to bring
air into the machine.
Avoid small locations or areas near exhaust fans.
Loading ...
Loading ...
Loading ...