Metabo HPT DH36DMAQ2 SAFETY INSTRUCTIONS AND INSTRUCTION MANUAL

Loading ...

English

Stopper

Mounting hole

Wing bolt

Fig. 19

6. Warming up (Fig. 20)

The grease lubrication system in this unit may require

warming up in cold regions.

Position the end of the bit so makes contact with the

concrete, turn on the switch and perform the warming

up operation. Make sure that a hitting sound is

produced and then use the unit.

Fig. 20

CAUTION

When the warming up operation is performed,

hold the side handle and the main body securely

with both hands to maintain a secure grip and be

careful not to twist your body by the jammed drill

bit.

7. How to use the drill bit (taper shank) and the taper

shank adaptor.

(1) Install drill bit with taper shank in the taper shank

adaptor. (Fig. 21)

Drill bit

(Taper shank)

Taper shank adaptor

Fig. 21

(2) Turn the power on and drill a base hole.

(3) After cleaning out dust with a syringe, attach the plug

to the anchor tip and drive in the anchor with a manual

hammer.

(4) To remove the drill bit with taper shank, insert a

cotter into the slot of the taper shank adaptor, place

supports under the Rotary Hammer and tap the cotter

with a manual hammer. (Fig. 22)

Taper shank

adaptor

Cotter

Support

Fig. 22

USING DRILL CHUCK, CHUCK ADAPTOR

Note that this machine can be used at “rotation only”

if separately sold parts such as drill chuck and chuck

adaptor are attached. Use it with the selector lever

positioned at “rotation + hammering”.

WARNING

During operation, be sure to grip the handle and

the side handle ﬁ rmly to prevent your body from

swaying.

CAUTION

To prevent accidents, make sure to turn the

switch oﬀ and pull out the battery.

(1) Switching to “rotation + hammering”

For switching to “rotation + hammering”, follow the

same procedures mentioned in [3. When drilling at

“rotation + hammering”] in Page 15

(2) Attaching chuck adaptor to drill chuck (Fig. 23)

(a) Attach the chuck adaptor to the drill chuck.

(b) The SDS max shank of the chuck adaptor is

equivalent to the drill bit. Therefore, follow the

same procedure as [3. How to install tool] in Page

13 for attaching and detaching.

Drill chuck

Grip

SDS max shank

Chuck

adaptor

Fig. 23

000BookDH36DMANA.indb16000BookDH36DMANA.indb16 2018/05/1410:40:092018/05/1410:40:09

Loading ...

Metabo HPT DH36DMAQ2 MultiVolt 36-Volt Brushless Cordless 1-9/16" SDS-Max Rotary Hammer Drill Tool Only

SAFETY INSTRUCTIONS AND INSTRUCTION MANUAL - Page 16