Loading ...
Loading ...
Loading ...
9
www.jblsynthesis.com
English
TROUBLESHOOTING
Symptom Solution
If there is no sound from any of the speakers
• Check that the receiver/amplifier is on and that a source is playing.
• Check all wires and connections between the receiver/amplifier and the speakers.
Make sure all wires are connected. Make sure none of the speaker wires are frayed,
cut, punctured or touching each other.
• Review the proper operation of your receiver/amplifier.
If there is no sound coming from one speaker
• Check the Balance control and channel output level settings on your receiver/
amplifier.
• Check all wires and connections between the receiver/amplifier and the speakers.
Make sure all wires are connected. Make sure none of the speaker wires are frayed,
cut, punctured or touching each other. In multichannel applications, make sure
that your receiver/processor has been configured to enable all channels that you
are using.
If there is low (or no) bass output, or you are
hearing only midrange frequencies (such as
vocals) through the subwoofer
• Make sure the connections to the speaker inputs have the correct polarity (+
and –). If you are using two SSW-3 subwoofers, try inverting the polarity on one
subwoofer.
• Some processors (receivers) and surround modes may have the subwoofer output
disabled initially. Consult your processor or receiver manual to learn how to
enable the subwoofer output.
• The crossover frequency to the subwoofer may be set too high. Consult your
processor or receiver manual to learn how to lower your subwoofer crossover
frequency.
If the system plays at low volumes but shuts
off as the volume is increased
• Check all wires and connections between the receiver/amplifier and the speakers.
Make sure all wires are connected. Make sure none of the speaker wires are frayed,
cut, punctured or touching each other.
• If more than one pair of main speakers are being used, check the minimum-
impedance requirements of your receiver/amplifier.
SPECIFICATIONS
Frequency Response 20 Hz – 150 Hz (-6 dB)
Maximum Recommended Amplifier Power 600 Watts RMS per channel
Impedance 4 Ohms nominal
Sensitivity 88dB (2.83 V / 1m), both woofers driven
Woofer Dual 10"/250 mm composite cones woofers
Dimensions of SSW-3BB enclosure (H x W x D) 64” x 14” x 5.1” (1626 mm x 356 mm x 130 mm)
Mounting Cutout Size (W x H) 15.5” x 66” (393.7 mm x 1676.4 mm)
Grille Size (W x H x D) 16.890” x 28.425” x 0.375” (429 mm x 722 mm x 9.53 mm)
Weight per Speaker 81 lb (36.75 kg)
All features and specifications are subject to change without notice.
The maximum recommended amplifier power rating will ensure proper system headroom to allow for occasional peaks. We do not
recommend sustained operation at these maximum power levels.
JBL, Harman International, JBL Synthesis and Synthesis are trademarks of Harman International Industries, Incorporated, registered in the
United States and/or other countries.
Styrofoam is a trademark of the Dow Chemical Company.
Loading ...
Loading ...
Loading ...