Loading ...
Loading ...
Loading ...
• Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged before you start the product.
Battery
WARNING: Read and understand the
safety chapter before you use the battery.
Read and understand the operator's manual
for the battery and the battery charger.
Keep the battery and the battery charger in the correct
ambient temperatures.
Ambient temperature
Operation of the battery 5 °C-40 °C / 41 °F-104 °F
Charging of the battery 5 °C-40 °C / 41 °F-104 °F
Battery status
The display shows the state of charge and if there are
problems with the battery.
(Fig. 38)
LED indicator Battery status (state of charge)
BLi10 40-B70
4 LED lights are on N/A The battery is 76% - 100% charg-
ed.
3 LED lights are on The battery is 76% - 100% charged. The battery is 51% - 75% charged.
2 LED lights are on The battery is 51% - 75% charged. The battery is 26% - 50% charged.
1 LED light is on The battery is 26% - 50% charged. The battery is 6% - 25% charged.
1 LED light flashes The battery is 0% - 25% charged. The battery is 0% - 5% charged.
To charge the battery
Charge the battery if it is the first time that you use it. A
new battery is only 30% charged.
CAUTION: Connect the battery charger
to a power outlet with the voltage and
frequency that is specified on the rating
plate.
The battery does not charge if the battery temperature is
more than 50 °C/122 °F.
1. Connect the power cord to the battery charger.
2. Connect the battery charger to a grounded power
outlet. The charging LED flashes one time. (Fig. 39)
3. Connect the battery to the battery charger. The
charging LED comes on. Charge the battery for
maximum 24 hours. (Fig. 40)
4. Push the battery indicator button, if all the LED
indicators come on, the battery is fully charged.
5. Pull the power plug to disconnect the battery charger
from the power outlet. Do not pull the power cord.
6. Remove the battery from the battery charger.
To connect the battery to the product
WARNING: Only use the initial
Husqvarna battery for the product.
1. Fully charge the battery.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click. (Fig. 41)
CAUTION: If the battery does not
move easily into the battery holder, the
battery is not installed correctly. This can
cause damage to the product.
To start the product
1. Push and hold the start/stop button until the green
LED comes on. (Fig. 42)
2. Push the power trigger lockout and the power
trigger. The cutting equipment starts to rotate.
To adjust the loop handle
1. Loosen the knob and adjust the loop handle to an
applicable position. (Fig. 43)
Note: Make sure not to attach or move the loop
handle onto the warning decals on the two-piece
shaft.
2. Tighten the knob.
Automatic shutdown function
The product has a shutdown function that stops the
product if the product is not used. The green LED for
1728 - 004 - 10.05.2023
13
Loading ...
Loading ...
Loading ...