Loading ...
Loading ...
Loading ...
OPERATION
To raise:
1. Park vehicle on a hard level surface safely
away from oncoming trafc.
2. Turn off the vehicle’s engine.
3. Place the vehicle’s transmission in PARK, if
equipped with an automatic, or in its lowest
gear, if equipped with a manual transmission.
4. Set the vehicle’s emergency brake and block
the wheels that are not being lifted.
5. Refer to vehicle owner’s manual for proper
jacking procedures. Lift only on areas of
vehicle as specied by manufacturer.
6. Make certain that load is centered on saddle.
7. Turn pump handle clockwise to close.
8. Pump to raise load to desired height.
9. ALWAYS support load with jack stands. (See
gure 2) Place jack stands of appropriate
capacity (not included) beneath the vehicle
at locations recommended by the vehicle
manufacturer. DO NOT Get under the vehicle
without jack stands. jacks are not designed to
maintain heavy loads for long periods of time.
DO NOT attempt to put jack stands simultane-
ously under both ends of vehicle or under one
side of vehicle. NOTE: When using two jack
stands, they must be at the same height.
10. SLOWLY turn the release valve counterclock-
wise to lower vehicle onto jack stands and
remove jack.
To lower:
1.
Remove all tools, parts, etc. from under the vehicle.
2. Position the saddle under the lifting point. Turn
the Handle rmly clockwise to close the valve,
and pump the upper/lower handle to raise
the vehicle slightly above the saddle(s) of the
jack stands. Then, collapse and remove jack
stand(s).
3. SLOWLY turn the release valve counterclock-
wise with the handle just enough to allow
controlled descent of the vehicle onto the
ground. (Never more than two full turns).
4. Lower the jack completely. Then, store in a
safe, dry location out of reach of children.
Figure 2
IMPORTANT: NEVER MOVE JACK WHEN THE HANDLE IS IN OPERATING LEVER OR THE
VALVE SLEEVE. DAMAGE TO THE PUMPING UNIT MAY OCCUR.
NOTICE During shipment or handling, air in the jack can become trapped in the hydraulic system
causing the jack to malfunction.
BEFORE USE
Release
Valve
Pump Handle Sleeve
Figure 1
Before using your jack:
1. Turn pump handle counter-clockwise no more
than two turns to open.
2. Pump jack about 6 full strokes to ensure
complete distribution of hydraulic uid.
(See Figure 1)
3. Repeat above steps as needed.
4
Loading ...
Loading ...
Loading ...