Loading ...
Loading ...
Loading ...
21
6. Attach one cable fitting to the junction box cable from the
dishwasher paying thorough attention to the orientation (see
below figure). The cable fitting shall tighten against the
secondary insulation (PVC jacket).
A
A. 0.25" (6.35 mm) minimum
Use wrench and/or pliers to fully tighten the elongated (strain
relief) nut against the strain relief body.
7. For Direct (home) wire connection (12-2/14-2 non-metallic
sheathed/Romex), Strip jacket insulation of the home wire to
expose the wires to the length of 5
1
/
16
" (129.3 mm) as shown
below. Strip each wire end by 0.75" (19 mm). Attach the
second cable fitting to home wiring paying attention to the
orientation (see below figure). Use wrench and/or pliers to
fully tighten the elongated (strain relief) nut against the strain
relief body.
B
A
C
A. 3
3
/
4
" (95 mm)
B. 0.75" (19 mm)
C. 0.25" (6.35 mm) minimum
8. For power cord connection, attach the second cable fitting to
the power cord paying attention to the orientation (see below
figure). Use wrench and/or pliers to fully tighten the elongated
(strain relief) nut against the strain relief body.
A
A. 0.25" (6.35 mm) minimum
NOTE: Non-metallic sheathed wire is for direct wire
connection only.
9. Route wire ends into the junction box through the round holes
on the sides. Securely attach the cable fittings to the junction
box using plastic mounting nuts supplied with the cable
fittings. Hand tighten the mounting nuts to the cable fittings
and then use a crescent wrench to tighten another 1/4 turn.
Use a second wrench or pliers to secure the cable fitting body
when tightening the mounting nut.
10. Connect wires together inside the junction box using the
supplied wire nuts. Connect wires of the same color together
(black to black, white to white, and bare/green to green).
NOTE: Do not pre-twist wires before making connections.
Wiring configuration
Home Wire or
Power Cord
Junction Box
Cable
white
white
black
black
bare/green
green
11. To apply a wire nut, hold the stripped/bare ends of wires
parallel to each other with their ends aligned. Firmly push
wires into a wire nut and twist clockwise until secure (the
insulated wires outside the connector begin to twist). Gently
tug on each wire making sure they are secure.
26-Jun-2023 08:47:55 EDT | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
Loading ...
Loading ...
Loading ...