Loading ...
Loading ...
Loading ...
18
4. Place the custom panel with the face side down on the
blanket, and note the planned top and bottom of the panel if
applicable.
A
B
C
A. 23
5
/
8
" (600 mm)
B. 22
1
/
16
" (560 mm)
C. 2
9
/
16
" (65 mm)
5. Using a tape measure, measure the top, center and bottom
width of the panel, and mark the center location with either the
edge of a tape piece or with a fine point pencil.
6. Using the straight edge draw a line connecting all the marked
center lines so that the center of the panel is identified.
7. Using the provided template, align the centerline of the
template with the center line of the door.
Awl Center punch
8. Using a center punch or awl, mark the 2 locations on the
template to be used for attaching the door studs. Remove the
template. Attach the 2 door studs to custom panel using the
included screws.
B
A
C
A. 3.5 mm x 18 mm Phillips head screw (2)
B. #2 Phillips screwdriver
C. Studs
9. Attach double sided adhesive to the door panel in the lower
half, to temporarily aid in door alignment. These pieces of
adhesive can be removed later after getting all the holes
perfectly aligned.
Double sided adhesive
10. Insert one of the wood blocks from the packaging across the
door opening to prop the door slightly open.
11. Align the two door studs to the referenced tracks on the door,
lifting up the door until the top panel is flush with the top of the
dishwasher door.
12. While holding the alignment, press on the lower section of the
door, to allow the double sided tape to grab and hold your
alignment.
13. If this process needs adjusting, Use a plastic putty knife
between the panel and the door to relieve the double sided
tape and free the panel.
14. Open the door and panel together to the fully open position,
making sure the panel has not shifted.
26-Jun-2023 08:47:55 EDT | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be automatically
replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")
Loading ...
Loading ...
Loading ...