Loading ...
Package Contents
Make sure all parts are present & place
them side by side for easy identification.
STEP 1
Find a healthy, strong hardwood tree that has a branch* that stretches at least 8
feet (2.4m) from its trunk and has a circumference** between 25
1
/
4
to 100 inches
(64.1 to 254cm). The tree branch should be at least 8 feet (2.4m) from the ground.
The tree trunk should have a circumference of at least 25
1
/
4
inches (64.1cm). The
tree and its branch should be strong enough to hold at least 200 lbs. (90.7 kgs.)***.
Clear the surrounding ground of debris prior to installing your swing. Make sure
the tree branch does not stretch: into a road, sidewalk, or street; over a
fence; someone else’s property; or any other obstacle.
*The tree branch must allow at least 12 inches (30.5cm) of clearance between the skateboard swing
& ground. The skateboard swing ropes are about 66 inches (167.6cm) in length.
**9-ft tree straps can only wrap around a tree branch of a max 100-inch (254cm) circumference.
Helpful hint: wrap tree straps around the tree branch for height adjusting purposes.
***Please note that the skateboard swing can only hold a person weighing up to 200 lbs.
Preassembled Skateboard Swing has:
4 Ropes
4 ‘O’ Rings
Wooden skateboard, &
Wooden handles
A
B
C
D
A
B
C
D
x1
x2
x2
PART
1
2
3
NAME QTY
Preassembled
Skateboard Swing
Carabiner Hooks
w/ Screw Lock
9-Ft Tree Straps
ASSEMBLY INSTRUCTIONS
AFTER READING ALL THE SAFETY INFORMATION ON
THIS PAGE AND THE FIRST PAGE, YOU MAY NOW
START TO ASSEMBLE YOUR
WOODEN SKATEBOARD SWING
USING THE FOLLOWING DIRECTIONS
CONSUMER INFORMATION SHEET FOR PLAYGROUND SURFACING MATERIALS
**The maximum fall height for this product is 60 in (152 cm).
We recommend using 6 in (15 cm) of Double Shredded Bark Mulch. **
Table 1 lists the maximum height from which a child would not be
expected to sustain a life-threatening head injury in a fall onto different
loose-ll surfacing materials if they are installed and maintained at depths
of 6, 9, and 12 inches. However, it should be recognized that all injuries
due to falls cannot be prevented no matter what surfacing material is used.
It is recommended that a shock-absorbing material should extend
a minimum of 6 ft. in all directions from the perimeter of stationary
equipment such as climbers and slides. However, because children may
deliberately jump from a moving swing, the shock absorbing material
should extend to the front and rear of a swing a minimum distance of 2
times height of pivot point measured from a point directly beneath the
pivot on the supporting structure.
This information is intended to assist in comparing the relative shock-
absorbing properties of various materials. No particular material is
recommended over another. However, each material is only effective when
maintained. Materials should be checked periodically and replenished to
maintain correct depth as determined necessary for your equipment. The
choice of a material depends on the type and height of the playground
equipment, the availability of the material in your area, and its cost.
2
Loading ...
Loading ...