Loading ...
Loading ...
Loading ...
23
• All gas installations of the dryer must be equipped with Manual Shut-
Off valve.
• Uncoated copper tubing will corrode when subjected to natural gas,
causing gas leaks. Use ONLY black iron, stainless steel, or plastic-
coated brass piping for gas supply.
• Check all gas connections for leaks using a soap solution.
• If bubbles appear, tighten the connections and recheck. DO NOT use
an open flame to check for gas leaks.
CONNECT THE GAS LINE (FOR GAS MODELS)
Review the “
Gas Requirements
” section on page 14. Remove the pipe
thread protective cap.
Apply a pipe joint compound or about 1 1/2" wraps of teflon tape over all
threaded connections.
• The pipe joint compound must be resistant to the actions of any
liquefied petroleum gas.
Connect the gas supply to your dryer. An additional fitting is required
to connect the 3/4" (1.9 cm) female thread end of a flexible connector to
the 3/8" (1 cm) male threaded end on the dryer. Use only new AGA or CSA
certified gas supply line with SS flexible connectors within 6 ft (1.8 m) of
the dryer.
Securely tighten the gas line fitting over the threads.
Turn on the gas supply.
Manual
Shutoff
Valve
Flare
Union GAS FLOW
Flare
Union
Open
Nipple Flexible
Connector
Inlet Pipe on
Back of Dryer
All connections must be wrench-tightened
WARNING
Dryer
Safety
Operation
Requirements
Parts and
Features
Installation
Instructions
Dryer Use
Dryer Care
Troubleshooting
Appendix
Loading ...
Loading ...
Loading ...