Loading ...
Loading ...
Loading ...
ASSEMBLY / PRE-OPERATION
INSTALL DISCHARGE CHUTE / CHUTE ROTATOR
HEAD (See Fig. 7)
NOTE: The multi-wrench provided in your parts bag may
be used to install the chute rotator head.
1. Place discharge chute assembly on top of chute base
with discharge opening toward front of snow thrower.
2. Position chute rotator head overchute bracket. Ifneces-
sary, rotate chute assemblytoalign square and pinon un-
derside of chute rotator head with holes in chute bracket.
3. With chute rotator head and chute bracket aligned,
position chute rotator head on pin and threaded stud
of mounting bracket.
4. Install 3/8 washer and Iocknut on threaded stud and
tighten securely.
CHUTE
ROTATOR
PIN
STUD
ROTATOR HEAD
CHUTE ALIGN BEFORE MOUNTING
BRACKET TIGHTENING LOCKNUT BRACKET
FIG. 7
INSTALL CHUTE DEFLECTOR REMOTE CONTROL
(See Figs. 8 and 9)
1. Install remote cable bracket to discharge chute with
5/16-18 carriage bolt and 5/16-18 Iocknut as shown.
Tighten securely.
2. Install remote cable eyelet to chute deflector with
1/4-20 shoulder bolt, nylon washer and 1/4-20 Iocknut
as shown. Tighten securely.
3. Install spring hooks between hex nuts on chute rotater
head and into hole in chute deflector as shown.
SPRING
1/4-20
SHOULDER CHUTE
HOOK
NYLON BETWEEN
WASHER HEX NUTS
ON CHUTE
1/4-20 ROTATER
LOCKNUT
CABLE
EYELET
5/16-18
CARRIAGE
BOLT
J
_B _EMoTE
CABLE
RAC KET
5/16-18
LOCKNUT
FIG. 8
\\
CHUTE DEFLECTOR
CONTROL LEVER
/i iii
FIG. 9
CHECK TIRE PRESSURE
The tires on your snowthrower were overinflated at the fac-
tory for shipping purposes. Correct and equal tire pressure
is important for best snow throwing performance.
Reduce tire pressure to 14-17 PSI (19-24.5 N-m).
Loading ...
Loading ...
Loading ...