Loading ...
Loading ...
Loading ...
4
INSTALLATION INSTRUCTIONS
Before Using Your Wine Cellar
Remove the exterior and interior packing.
Before connecting the wine cellar to the power source, let it stand upright for
approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Installation of Your Wine Cellar
This appliance is designed for free standing or built-in (fully recessed) installation.
If free standing, the unit should have at least 4” of clearance at both sides, at the
top and at the back to allow for adequate ventilation. If it is built-in, leave at least
3/16” at both sides, 1/16” at the top and 2” at the rear. Be sure that airflow under
the appliance is not blocked.
Place your wine cellar on a floor that is strong enough to support it when it is fully
loaded. To level your wine cellar, adjust the front leveling legs at the bottom of
the unit.
Locate the wine cellar away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. Extremely cold ambient
temperatures may also cause the unit to perform improperly.
Avoid locating the unit in moist areas.
Plug the wine cellar into an exclusive, properly installed and grounded wall outlet.
Do not under any circumstances cut or remove the third (ground) prong from the
power cord. Any questions concerning power and/or grounding should be
directed toward a certified or authorized products service center.
Reversing the Door Swing of Your Appliance
This appliance has the capability of the door opening from either the left or right
side. The unit is delivered to you with the door opening from the left side. Should
you desire to reverse the opening direction, please follow these instructions. To
make the reversal, you will find two hardware pieces in a plastic bag inside the
appliance: the top left hinge and the bottom left hinge. The bottom support bracket
is used for both sides.
1. Carefully lay the appliance on its back. Use cushioning to protect the floor and
appliance.
Loading ...
Loading ...
Loading ...