Loading ...
Loading ...
Loading ...
Read these instructions completely and carefully.
Connect the Tubing to the Refrigerator
Before making the connection to the
refrigerator, be sure the refrigerator power
cord is not plugged into the wall outlet.
If your refiigerator does not have a water filter, we
recommend installing one if your water supply has
sand or particles that could clog the screen of the
refrigerator's wamr valve, lnslall it in tile water line
near the retiigerator.
O Relilove access cover.
Remove the plastic flexible cap fiom the water
valve (refrigerator (onne(tion).
Place tile compression nut and ferrule (sleeve)
onto tile end of the robing as sho_l.
Insert tile end of tile robing into tile water valve
refrigerator connection as flu as possible. While
holding tile robing, tighten tile fitting.
Fasten tile robing into tile clamp provided to
hold it in position. You may need to PU open
the clamp.
Replace access covei.
Theillustrationbelow wi// look like theconnectionon your
refngerator
Tubing
Clamp
1/4"
Nut
Ferrule
(sleeve)
Connection
RemoveCover "-\
_e
1/4"Tubing
Turn the Water On at the Shutoff Valve
Tighten any (onne(tions dial leak. Replace tile access covei and sciews (on soiile
models).
Plug In the Refrigerator
Artvmge tile coil oftubing so that it does not vibrate
against tile back of tile refrigerator or against tile
wall.
Push tile refiigerator back to tile wall.
Start the Icemaker
Set tile icemaker power switch to tile ONposifion.
Tile icemaker will not begin to operate until it
reaches its operating temperature of 15°F (-9°C) or
beh)w. It will then begin operation mltomafically if
the icemaker power switch is in the ONposifion.
NOTE: In lower water pressure conditions, the
water valve may turn on up to 3 times to make
sure enough water reaches the icemaker.
21
Loading ...
Loading ...
Loading ...