Loading ...
Loading ...
Loading ...
(select models)
The Delay/Resume option can be used to
automaticallystart the cycle at a later time,
such as during off-peak hours for reduced
energy cost or to reduce daytime heat
buildup in the home.
TO SET UP A DELAY:
1. Select the appropriate cycle and
optionsfor the load.
2. Press the Delay/Resume pad untitthe
desired amount of delay time (I to £
hours) is selected. The delay time will
begin counting down when the pad is
released.
3. The DelaylResume indicator light will
remain lit until the delay time has
counted down,
4. The cycle will automatically start as
soon as the delay time expires,
| If Delay/Resume is chosen with-
out selecting a cycle and/or
options,the dishwasherwill select
the last cycle used. (It will not
rememberthe Rinse Only cycle,)
TO CANCEL A DELAY:
Wait at least 2 seconds, then press the
Delay/Resume pad again. The indicator
light will go out and the cycle witl start or
resume immediately.
The control touchpads can be locked to
prevent unwanted use. If this feature is
activated between cycles, the dishwasher
cannot be operated untit the controls are
unlocked. If desired, the controls can be
locked after a cycle or delay has started,
SETTING THE CONTROL LOCK:
,
2.
Press the _ pad for three seconds.
An indicator light above the pad will
illuminate when the controts are
locked.
TO CANCEL:
1. Pressthe _ pad for three seconds,
2. The indicator lightwitl go off.
| If a cycle or option pad is pressed
after the controls have been
locked, the indicator light above
the Control Lock pad will flash
five times.
7
TARTINGTHE
,
2.
Afterloadingthe dishwasherandadding
detergent, close the dishwasher by
pressingthe door untilthe latchclicks.
To start the dishwasher, firmly press
the desired cycle and options pads.
After a pause,the fill will begin. Topre-
vent unplanned cycle or option
changes, these selections are "locked
in" after I minute.
| If a cycle or option pad is pressed
afterthecontrolshavebeen"locked
in", the light above the Control
Look padwill flashfive times.
3. The indicator lights for the selected
cycle and options will glow.
4. To cancel an option, press the pad
again. To cancel a cycle, press the
Drain/Off pad.
k FORGOTTENITEM
For best cleaning, the forgotten item
should be added early inthe cycle.
1. Press the Delay/Resume pad or
unlatch the door.
2. Wait for the water circulation to stop.
3. Open the door and add the item.
4. Close and latch the door.
I If Delay/Resume was pushed,
push it again to restart the dish-
washer.
5, After five seconds, the cycle resumes
automaticallyat the pointof interruption.
Loading ...
Loading ...
Loading ...