Loading ...
Loading ...
Loading ...
en Basic settings
18
Display Basic setting Selection
Waiting time until a setting is adopted = 3 seconds
1
= 6 seconds
= 10 seconds
Button tone when pressing a button = off
= on
1
Brightness of the display illumination = dark
= medium
1
= bright
Time display = hide the time
= display the time
1
Childproof lock can be adjusted
→"Childproof lock", Page17
= no
= yes
1
Interior lighting during operation = no
= yes
1
Cooling fan run-on time = short
= medium
1
= long
= extra long
Telescopic shelves retrofitted
2
= no
1
(for rails and 1-level pull-out)
= yes (for 2- and 3-level pull-out)
Sabbath mode available = no
1
= yes
Water hardness
→"Setting the water hardness", Page18
= softened
= soft (up to 1.5mmol/l)
= medium (1.5–2.5mmol/l)
= hard (2.5–3.8mmol/l)
1
= very hard (above 3.8mmol/l)
Automatic rapid heating from 200°C
2
= no
= yes
1
Reset all values to factory settings = no
1
= yes
.. HomeConnect Settings
→"HomeConnect ", Page19
1
Factory setting (may vary according to model)
2
Depending on the appliance specifications
13.2 Changing basic settings
Requirement:The appliance is switched off.
1.
Press and hold the
button for approximately
fourseconds.
a The first basic setting appears in the display,
e.g.
.
2.
Use the temperature selector to change the setting.
3.
Use the or button to switch to the next basic set-
ting.
4.
To save the changes, press and hold the button
for approx. fourseconds.
Note:Your changes to the basic settings will be re-
tained even after a power failure.
13.3 Discarding changes to the basic
settings
▶
Turn the function selector.
a All changes are discarded and not saved.
13.4 Setting the water hardness
ATTENTION!
If the wrong water hardness has been set, the appli-
ance cannot remind you to descale it at the right time.
▶ Set the water hardness correctly.
Using unsuitable liquids may damage the appliance.
▶ Do not use distilled water, highly chlorinated tap wa-
ter (>40 mg/l) or other liquids.
▶ Only use cold, fresh tap water, softened water or
non-carbonated mineral water.
Requirements
¡ Before you set the water hardness, ask your water
supplier about the hardness of your tap water.
¡ The appliance must be switched off.
1.
Press and hold the
button for approximately
fourseconds.
a The first basic setting appears in the display,
e.g.
.
2.
Use the or button to switch to the next basic set-
ting
.
3.
Use the temperature selector to set the water hard-
ness.
Loading ...
Loading ...
Loading ...