Loading ...
Loading ...
Loading ...
46 47
GB GB
Press S1 or S2 on the control panel to match the Robotic Mower's signal to
the docking station's. The button of the currently active signal is illuminated.
Home & start button
Press the START button and close the top cover and the Robotic Mower will begin cutting.
When the programmed work time is passed, the device will return to the docking station.
Important note:
The Robotic Mower will start working again the following day at the same time as when the
start button was pressed initially.
Example: You start the Robotic Mower on Monday at 15:30 with a working time of 4 h. The
device will work on Monday until 19:30 and then return to base. On Tuesday 15:30, the
Robotic Mower will automatically start again working for the same 4 h. This will continue
every day until interrupted by the user.
HOME
Pressing the HOME button and closing the lid will send the Robotic Mower back to the
docking station for a complete recharge. Note this will not stop the current programming. If
the working time has not run out when charging is complete, the device will start cutting
again. It will also start working again on the following day.
STOP
To interrupt the automatic working schedule, press the STOP button to open the top cover,
and close it again without pressing any control button. The Robotic Mower will beep ve
times to conrm the interruption. It will not resume working without further user commands.
OPERATION
OPERATION
Edge cutting
As the rst cutting action of each day, the Robotic Mower will trim the lawn edge. Therefore,
while cutting, it follows the boundary wire in clockwise direction.
This function only engages when the Robotic Mower launches from the charging
station.
Charging Information
The Robotic Mower will go back to docking station by itself in the following situations:
1. When you press the
button and close the keypad top cover.
2. When out of working time set.
3. When less than 30 % battery charge is remaining.
Note: If the Robotic Mower fails to dock to the docking station, it will return to the cutting
area and try again.
Note: If the ambient temperature around docking station is higher than 40 °C, the device will
stop charging to protect the battery. Once the temperature drops sufciently, charging will
resume automatically.
Loading ...
Loading ...
Loading ...