Loading ...
Loading ...
Loading ...
87
INSTALLATION
ELECTRICAL OUTLET AND ANTI-TIP BLOCK
To reduce the risk of tipping the drawer, the anti-tip block must be properly located
14 above the floor on which the microwave drawer will sit. The 6” anti-tip block
must be provided by the installer. The anti-tip block prevents serious injury that might
result from spilled hot liquids. If the microwave drawer is ever moved to a different
location, the anti-tip block must also be moved and installed. When secured to the
wall, make sure that the screws completely penetrate the dry wall and are secured in
wood or metal so that the block is totally stable. When fastening, be sure that the screws
do not penetrate electrical wiring or plumbing. The electrical requirements are 120
volt, 60 Hz, AC only, 15 amp. It is recommended that a separate circuit serving only
this appliance be provided. The drawer is equipped with a 3-prong grounding plug
and must be plugged into a wall receptacle that is properly installed and grounded.
Should you only have a 2-pring outlet, have a qualified electrician install a correct wall
receptacle.
NOTE: If you have any questions about the grounding or electrical instructions, consult
a qualified electrician or service person. The microwave drawer can also be installed
using an electrical outlet in an adjacent cabinet within the area where the provided
electrical cord can reach. ALWAYS check electrical cord can reach.
GROUNDING INSTRUCTIONS
This appliance must be grounded. The microwave drawer must be plugged into a wall
receptacle that is properly installed and grounded in accordance with the National
Electrical Code along with local codes and ordinances. In the event of an electrical
short circuit, grounding reduces risk of electrical shock by providing an escape wire for
the electrical current.
WARNING: Improper use of the grounding plug can result in the risk of
electric shock. Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install an outlet near the
appliance.
WARNING
installation instructions
INSTALLATION
DRAWER INSTALLATION
1. Place the drawer adjacent to the wall or cabinet opening. Plug the power supply
cord into the electrical outlet.
2. Carefully guide the drawer into the prepared opening. Avoid pinching the cord
between the oven and wall.
3. Slide the drawer all the way until the mounting flange is flush with the face of the
cabinet.
4. Open the drawer. Using the four holes on the drawer as a template, pre-drill the
cabinet using a 1/16” bit.
5. Secure the drawer with the four screws supplied.
Drawer Installation
Electrical Outlet & Anti-Tip Block
Loading ...
Loading ...
Loading ...