Simpson Cleaning PS3835-S User Manual

Loading ...

15 - ENG

NOTICE: Riskofpropertydamage.Neverpullwatersupplyhosetomovepressure

washer. This could damage hose and/or pump inlet.

• DONOTusehotwater,usecoldwateronly.

• Neverturnwatersupplyoffwhilepressurewasherengineisrunningordamageto

pumpwillresult.

• DONOTstopsprayingwaterformorethantwominutesatatime.Pumpoperates

inbypassmodewhensprayguntriggerisnotpressed.Ifpumpisleftinbypass

modeformorethantwominutesinternalcomponentsofthepumpcanbe

damaged.

If you do not understand these precautions, please contact our customer service

department at www.simpsoncleaning.com

Prior to starting, refer to your engine manual for proper starting procedure.

1. In a well ventilated outdoor area add fresh, high quality, unleaded gasoline

with a pump octane rating of 86 or higher. Do not overfill. Wipe up spilled

fuel before starting the engine. Refer to Engine Owner's Manual for correct

procedure.

NOTICE: Useoffuelswithgreaterthan10%ethanolare

notapprovedforuseinthisproductperEPAregulations

andwilldamagetheunitandvoidthewarranty.

2. Check engine oil level. Refer to Engine Owner's Manual for correct procedure.

3. Check pump oil level. The oil level should come to the dot in the middle of the

sight glass. Refer to the Pump paragraph under Maintenance.

4. Connect the water hose to the water source. Turn the water source on to

remove all air from the hose. When a steady stream of water is present, turn

the water source off.

5. Verify the filter screen (Q) is in water inlet of pump. NOTE: Convex side faces

out.

6. Connect water source (N) to pump inlet (J). NOTE: Water source must provide

a minimum of 5 gallons per minute at 20 PSI.

7. Connect

high pressure hose (C) to pump outlet (I).

WARNING: To reduce the possibility of contamination always protect

against backflow when connected to a potable water system.

8. Choose the correct nozzle for the job to be performed. See How To Use spray

Wand instructions in this section. NOTE: If applying a chemical or cleaning

solution, see How To Apply Chemicals/Cleaning Solvents instructions in this

section.

9. Turn water source on.

NOTICE: Risk of property damage. Failure to do so could cause damage to the

pump.

Loading ...

Simpson Cleaning PS3835-S PowerShot PS3835