Loading ...
Loading ...
Loading ...
11
Left Side
In order to prevent the oven from tipping forward as shown on the
previous page, we need to make sure both chains provided with
the oven are used.
On the left side of the oven a 16mm drill bit was used to drill
through the cabinetry into the adjacent cabinet, as you can see the
hole has not been drilled hard up against the wall because there is
a 16 mm board at the rear of the cabinet. The heigt of the hole
from the floor is level with where the chain attaches to the oven.
The right side has been drilled much the same, a new hole has
been drilled below the gas and power supply hole
Right Side
Once the holes have been drilled the chains can be fed trough
and the upright can be fitted into position.
The chains then need to be pulled as tight as possible from inside
the cabinet using a self drilling wood screw. It is better to have the
screw fixed closer to the hole for better support. The left and right
side examples shown have two extra screws attached to the chain
which makes the installation neater by keeping the chain off the
shelf away from the gas and electricity supply, they will also
provide added support.
At this point the oven will be secured in location and will not move
forward at all, it is recommended that all upright oven chains be
fitted in this way.
Installation forms part of the installer compliance and that in line
with AGA regulations chains are designed to be installed to
prevent cooker from tilting. They are not designed to replace
parental supervision when the cooker is in use.
Loading ...
Loading ...
Loading ...