Loading ...
Loading ...
Loading ...
8
Connecting the water supply
IMPORTANT: Improper water line connection may result in flooding. Professional installation is
recommended. Review state and local plumbing codes before installation.
The ice maker requires a continuous water supply with a minimum pressure of 15 psig
and a static pressure not to exceed 80 psig.
The temperature of the water feeding into the ice maker should be between 41°F and
90°F for proper operation.
Deionized water is not recommended for use with this unit.
Ensure that hoses are not damaged during installation and check for leaks after
connecting the water line.
Connecting the drain line
The drain line must be connected before using the ice maker. If there is a drain line near the ice
maker or if the unit is to be used outside, it is best to drain water to the drain line through the
drain hose provided with the ice maker.
1. Locate the floor drain near the ice maker. The length of the drain hose provided is 5 feet.
Remove the rear drainage plug from the drain outlet at the rear of the ice maker. Connect
the nut of the drain outlet to the water draining hose, and insert the other side of the hose
into the drain line. Never allow the drain hose to hang or loop higher than the bottom of
the ice storage bin.
2. All horizontal runs of drain lines must have a fall of ¼ inch per foot. An air gap will likely
be required between the ice maker drain tube and the drain/waste receptacle. A
standpipe with a trap below it or a floor drain is acceptable for the drain/waste receptacle.
3. Pour 1 gallon of water into the ice storage bin to check for leaks in the drainage system.
Tighten any connections that leak.
IMPORTANT: This ice maker is not a freezer. Infrequent drainage will cause a high rate of
melting in the ice storage bin.
10
W W W . V I N O T E M P . C O M
1
3
2
Connecting the water line
Step 1 , Press the O-ring collect and Pull out the plug;
Step 2 , Insert the 1/4'' tube to the quick fitting;
Step 3 , Insert the locking clip to the quick fitting;
Step 4 , Connect the female adapter to faucet, open up and CHECK FOR LEAKS.
Loading ...
Loading ...
Loading ...