Loading ...
Loading ...
Loading ...
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas supplies before servicing. Check appliance is safe when you have nished.
41
A
B
ArtNo.311-0010 Injectors
A – Jet, B – Jet
2 Hotplate
2.1 To Remove the Hotplate Top
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Caution
- The ceramic hob material is much more sensitive to
scratches on the underside than the top.
Take care not to touch or scratch the underside of the ceramic
as this will weaken the material and cause the top to shatter.
Remove the pan supports, hotplate burner caps and tops.
Remove the screws holding the hotplate burners to the
hotplate (Fig. 12.3).
Taking care not to damage the burner electrodes, carefully lift
the hotplate, from underneath disconnect the earth lead at
the right hand rear from the rear cross member and withdraw
the hotplate.
Reassemble in reverse order ensuring that the leads are
reconnected. Take care not to damage the ignition electrodes
of the burners.
It is important that the rear earthing leads are replaced when
the xing screws are retted as they from part of the cooker
earthing.
Check for correct burner operation.
2.2 To Change a Hotplate Tap
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the control panel and hotplate (see 1.2 & 2.1).
Unplug the FSD lead from the rear of the tap. Undo
compression tting at the rear of the tap. Remove the xings
that secure the tap to the gas rail. Disconnect the ignition
switch wiring.
Remove the tap. Remove and discard the gasket seal. Fit new
gasket seal to replacement tap. Re-assemble in reverse order.
Check the appliance is gas sound. Check hotplate ignition.
2.3 To Replace a Hotplate Burner Injector
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the burner cap and head (Fig. 12.4). Remove the old
injector. Fit the new injector.
NOTE: The wok burner has 2 injectors.
Reassemble in reverse order. Check that the appliance is gas
sound.
2.4 To Change a Hotplate Burner Electrode
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Lift o the pan supports and remove the burner cap. Remove
the screw holding the electrode. Pull the electrode vertically
up suciently to grip the lead between thumb and forenger.
Pull o the electrode, but keep hold of the lead.
Fit the new electrode to the lead. Fix the electrode in the
burner with the screw.
Replace the burner cap. Check the burner ignition. Replace
the pan supports.
Fig. 12.3
Fig. 12.4
Standard burner
Loading ...
Loading ...
Loading ...