Loading ...
Loading ...
Loading ...
5.2 CORRECT POSITIONING:
The jack should be positioned under the approved lifting points for the vehicle. Since these points
may vary with each vehicle, it is important to refer to the vehicle manufacturer’s or Haynes
workshop manuals.
5.3 TERRAIN:
The jack should be operated on a hard and
level surface as the location will permit,
concrete is preferred.
✘
5.4 NEVER EXCEED THE JACK’S
RATED CAPACITY.
Never work under a vehicle without axle
stands correctly supporting the vehicle weight.
5.5 WORKING UNDER THE
VEHICLE:
It is extremely important, when working under
the vehicle, to ensure axle stands are always
used.
5.6 SAFETY PRECAUTIONS
1. The vehicle to be lifted should never exceed the rated capacity of the jack.
2. The maximum stroke of the jack indicated on the label should never be exceeded.
3. The jack should be supported on a solid, level and horizontal surface which is well illuminated
and free of obstructions. Never stand the jack on a surface which may sink.
4. Ensure that there are no persons inside the vehicle to be lifted. Switch off the engine and apply
the brake. Ensure the vehicle or element to be lifted against any type of sliding. Use chocks if
appropriate (1). Do not enter the vehicle or start the engine whilst it is supported on the jack or
appropriate stands. The jack is a lifting device only and should never be used to move the
vehicle.
5. Position the jack under the manufacturer’s recommended lifting point for the vehicle and
ensure that it is not corroded, dirty or greasy. This point should remain centred over the jack
saddle. All off-centred loads can slip and accidents may result.
6. During raising and lowering of the load, all precautions should be taken to avoid movement of
the vehicle load. Traffic may cause the raised vehicle to rock during roadside use of the jack.
7. The jack should be positioned so as to avoid the need for the user to introduce any part of
his/her body underneath the vehicle. Never work under a raised vehicle without supporting it
with axle stands (5) or other appropriate methods. Never position any part of your body near
the movable elements of the jack.
8. It is necessary for the operator to be able to observe the lifting device and the load during all
movements. In the presence of dangerous conditions, such as movement of the vehicle, etc,
the lifting process must be interrupted.
9. Ensure that there are no persons or obstructions underneath the vehicle prior to lowering.
10. As an additional safety measure against overload, the jack is fitted with an overload valve set
at the factory and which should not be adjusted under any circumstances. If the capacity of the
jack is exceeded, the overload valve will stop the lifting operation.
Caution:
● Use only on a firm, level surface, concrete is preferred.
● Do not exceed the rated capacity of this jack.
● This is a lifting device only...do not work under the vehicle without proper support devices, such
as axle stands.
● Make sure that the lifting point is stable and correctly centred on the jack saddle.
● Familiarize yourself thoroughly with this manual before operating to prevent damage to the
jack, property, or personal injury.
5.1 BEFORE POSITIONING THE JACK, YOU SHOULD
ENSURE THE FOLLOWING:
i. Vehicle should be clear of all passengers.
Transmission should be in gear (or ‘Park’
for automatic transmissions) and the
handbrake applied.
ii. To prevent vehicle from movement, wheels
should be securely blocked with wheel
chocks (Draper Stock No.54500).
5. HEALTH AND SAFETY INFORMATION
- 6 -
- 7 -
5. HEALTH AND SAFETY INFORMATION
✘
✓
1
P
Loading ...
Loading ...
Loading ...