Loading ...
Loading ...
Loading ...
4. INTRODUCTION
4.1 SCOPE
This jack is designed for light duty domestic use. To lift vehicles to the maximum stated weight limit.
Warning – extremely important!
● Read these safety instructions carefully in addition to the instructions for use, operation and
maintenance. Keep this instructions sheet in an easy to find place as you may need to use it
again.
● Adequate protective/safety footwear must be worn.
This jack has been designed for use in the elevation of vehicles. Any other application, beyond
the conditions established for use of this jack will be considered inappropriate.
– Handle the jack correctly and ensure that all parts are in good condition prior to its use.
– Only authorised persons should operate the jack having read carefully and understood the
contents of this manual.
– Do not modify the jack in any way.
– Non-compliance with these rules may result in injury or damage to the user, the jack or the
vehicle to be lifted.
– The manufacturer accepts no responsibility for the improper use of the jack.
4.3 HANDLING AND STORAGE
Care must still be taken when handling and lifting. Dropping this jack will have an effect on the
jack and may also result in personal injury. This jack is not a toy and must be respected.
The environment will have a negative result on its operation if you are not careful. If the air is
damp, components will rust. If the jack is unprotected from dust and debris; components will
become clogged: and if not cleaned and maintained correctly or regularly the jack will not perform
at its best.
- 5 -
4.2 SPECIFICATION
Stock No:...................................................................................................................................53089
Part No: ................................................................................................................................ TJ3HD/B
Rated load ............................................................................................................................... 3000kg
Maximum lifting range ...................................................................................................145 – 520mm
- 8 -
6. OPERATING INSTRUCTIONS
6.1 OPERATING
1. Prior to operating the jack, remove any accumulated air from the system as follows:
2. Handle assembly:
– Join two halves of the handle shaft, and secure together with screw provided.
– Insert handle shaft into base socket and secure with bolt.
3. Rotate the handle anti-clockwise then pump the jack several times with its full stroke to ensure
internal lubrication and bleed the accumulated air from the system.
4. Rotate handle clockwise to close the valve completely. The jack is now ready to be used.
5. Important: Prior to lifting the load, ensure that all of the aforementioned safety instructions are
followed.
6. The wheels of the jacks should always rotate freely.
7. For lifting:
Pump the handle to position jack saddle pad into position below approved vehicle lifting
point (check correct position with vehicle manufacturer before lifting).
Once the jack contacts the lift point, move the handle up and down, using the full stroke range
of the piston for greater speed.
Secure the lifted load as an essential safety measure with an appropriate axle stand.
8. Before lowering, lift the vehicle to remove the axle stands, ensuring that there are no persons
or obstacles under the vehicle to be lowered.
Carefully rotate the handle anti-clockwise to gently lower the load.
Loading ...
Loading ...
Loading ...