Loading ...
Loading ...
Loading ...
7. Plug the Extension Wire (49) that is coming out of the
top of the Upright (2) into the Handlebar Wire (87)
extending from the Handlebar (7).
Slide a Plastic Sleeve (53) onto each of the threaded
shafts on the Upright (2) as shown.
Note: It will be easier to perform this step If one
person holds the Handlebar in place white another
tightens the Bolts. Attach the Handlebar (7) to the
Upright (2) with the two M10 x 25mm Button Head
Bolts (85). Todo this, slide an M10 Washer (71) onto
each Bolt. Slide the Bolts through the brackets on the
Handlebar. Slide an M16 Flat Washer (84) onto each
Bolt. Slide a Metal Handlebar Spacer (83) onto each
Bolt. Slide the Bolts into the threaded holes in the
Upright and tighten them with the included allen
wrench.
Do not overUghten the Button Head Bolts (85); It
must be easy to pivot the Handlebar (7).
8. Attach the Backrest (40) to the indicated brackets on
the Upright (2) with four M6 x 16mm Seat Screws (28).
9. Identify the Left Pedal Leg (3) by looking at the
Lock Pin (90) on the pre_ssembled Toe Pedal (36).
The Lock Pin must be on the outside when the
Pedal Leg is mounted.
Attach a Pedal (29) to the Left Pedal Leg (3) with three
M4 x 16mm Tapping Screws (30).
Lubricate a Pedal Bolt (8) with the included grease
pack and slide it through the two pre-assembled
Bushings (39). Slide a Plastic Pedal Spacer (42) onto
the Pedal Bolt (8) and slide the Bolt into the hole in the
left CrankArm (10). Tighten a 1/2" Nylon Locknut (9)
onto the Pedal Bolt (8).
Repeat this procedure for the Right Pedal Leg (70, not
shown).
85
71
8
28
8;
Threaded Shaft
4O
8 Lubricate
7
Loading ...
Loading ...
Loading ...