Loading ...
Loading ...
Loading ...
Icemaker
Sblstem
Condenser
Care and Cleaning
/cemaker
:[. Press and hold the OFFbutton for 3 seconds.
2. Wait 5 to 10 minutes for the ice to fall into the
storage bin. Remove all ice from the storage
bin.
3. Unscrew the drain cap from the bottom of the
water reservoir located inside the storage bin as
shown. Allow the water to drain completelg.
D_aincapj Waterreservoir
4. Replace the drain cap.
5. For best results, use the entire 16 oz. bottle
of Nickel Safe Ice Machine CleanenFollow
all safetg precautions on the bottle. Pour one
bottle of solutionintothewater reservoinFill
the bottletwice with tap water and pour it into
thewater reservoin
Nickel Safe Ice Machine Cleaner bg Nu Calgon
is available at appliance repair shops,or through
GEParts and Accessories. Order part number
WXO8X42870.Inthe U.S.A.,call 800.626.2002orvisit
monogram.com. InCanada,call 1.800.561.3544.
6. Press and hold the CLEAN button for 5
seconds. The CLEAN light will begin to blink,
indicating that the cleaning cycle is in
process. The cleaning time is approximately
70 minutes.
• • •
®®@
HOLD3 SEC.
7. When the indicator light becomes solid and
remains lit, the cleaning cgcle is complete.
During the cleaning cgcle, the sgstem will
both clean and rinse itself.
8. After the cleaning cycle is complete, remove
the drain cap from the water reservoir to see
if an9 cleaning solution, green in color, is left
in the water reservoir. If cleaning solution
drains from the water reservoir, you should
run the clean cycle again adding only tap
water to the reservoir. Be sure to replace
the drain cap before running the cycle again.
If the cap is not securely tightened, water can
leak, causing thin ice or no ice.
NOTE:Severescalebuildup mag require repeated
cleaningwith a fresh quantitg of cleaning solution.
9. Press the ON button for 3 seconds to resume
ice production.
For best performance, brush or vacuum lint and
dirt from the condenser at least once a yean
A dirty or clogged condenser:
• Usemore energg..
• Prevents proper airflow.
• Reduces ice making capacitg.
• Causes higher than recommended operating
temperatures which may lead to component
failure.
1, Unplug the icemaker or disconnect pewen
2. Remove the 2 screws in the lower access
panel and the 2 screws from the base grille
area of the front panel support. Pull forward
to remove the lower access panel.
3. Pull the bottom forward and then pull down
to remove the lower access panel.
4. Remove dirt and lint from the condenser fins
and the unit compartment with a brush
attachment attached to a vacuum cleaner.
5, Replace the lower access panel using
the/4 screws.
6. Plug in the icemaker or reconnect powen
Z2
Loading ...
Loading ...
Loading ...