Loading ...
Loading ...
Loading ...
Page 14
Operating
Instructions
Other features
Water drainage
· During dehumidifying modes, remove the upper
drain plug from the back of the unit, install the drain
connector(5/8" universal female mender) with 3/4"
hose(locally purchased). For the models without drain
connector, just attach the drain hose to the hole.
Place the open end of the hose directly over the drain
area in your basement floor.
· If you can set the humidity level (portable with
humidity sensor), please put the back duct for best
dehumidification effect, but the back duct doesn’t
need to connect to window. If you can’t set the
humidity level (portable without humidity sensor),
please don’t put the back duct.
Remove the
upper drain
plug
Continuous
drain hose
Press the power cord buckle
into the rear cover.
FOLLOW ME/TEMP SENSING feature
NOTE:This feature can be activated from the remote
control ONLY. The remote control serves as a remote
thermostat allowing for the precise temperature
control at its location.
To activate the Follow Me/Temp Sensing feature, point
the remote control towards the unit and press the
Follow Me/Temp Sensing button. The remote display is
actual temperature at its location. The remote control
will send this signal to the air conditioner every 3
minutes interval until press the Follow Me/Temp
Sensing button again. If the unit does not receive the
Follow Me/Temp Sensing signal during any 7 minutes
interval, the nit will exit the Follow Me/Temp Sensing
mode.
NOTE: This feature is unavailabe under FAN or DRY
mode.
AUTO-RESTART
If the unit breaks off unexpectedly due to the power
cut, it will restart with the previous function setting
automatically when the power resumes.
WAIT 3 MINUTES BEFORE RESUMING OPERATION
After the unit has stopped, it can not be restarted
operation in the first 3 minutes. This is to protect the
unit. Operation will automatically start after 3 minutes.
AIR FLOW DIRECTION ADJUSTMENT
The louver can be adjusted automatically. Adjust the
air flow direction automatically:
· When the Power is ON, the louver opens fully.
· Press the SWING button on the panel or remote
controller to initiate the Auto swing feature. The
louver will swing up and down automatically.
· Please do not adjust the louver manually.
√
drain hose
adaptor
Continuous
drain hose
Remove the
lower drain plug
NOTE: During cooling mode, please reinstall the upper
drain plug to the unit securely to reach the maximum
performance and avoid leakage.
· During heating pump mode, remove the lower drain
plug from the back of the unit, install the drain
connector (5/8" universal female mender) with 3/4"
hose(locally purchased). For the models without drain
connector, just attach the drain hose to the hole. Place
the open end of the Hose adaptor directly over the
drain area in your basement floor.
NOTE: Make sure the hose is secure so there are no leaks.
Loading ...
Loading ...
Loading ...