Loading ...
Loading ...
Loading ...
Page 12
Operating
Instructions
Timer button
Used to initiate the AUTO ON start time and
AUTO OFF stop time program, in conjuction
Sleep(Eco)/Filter button
Used to initiate the SLEEP/ECO operation.
NOTE: After 250 hours of operation, the filter
indicator light illuminates. This feature is a
reminder to clean the Air Filter for more
efficient operation. Press this button for 3
seconds to cancel the reminder.
Mode button
Press this button to choose AUTO, COOL, DRY,
FAN mode. The
indicator light illuminates.
NOTE: On dry mode, you can adjust the
humidity for some models.
Power button
Power switch on/off.
Up (+) and Down (-) buttons
Used to adjust (increasing/decreasing)
temperature settings in 1°C/1°F(or 2°F)
increments or the TIMER settings in a range
of 0~24hrs or The humidity settings in a range
of 35%RH(Relative Humidity) to 85% RH
(Relative Humidity) in 5% incerments(For some
models).
NOTE: The control is capable of displaying
temperature in degrees Fahrenheit or degrees
Celsius. To convert from one to the other, press
and hold the Up and Down buttons at the same
time for 3 seconds.
LED display
Shows the set temperature in °C or °F and the
Auto-timer settings and the humidity settings
(only for modles with humidity sensor). While
on DRY and FAN modes, it shows the room
temperature. Shows Error codes and protection
code:
E1-Room temperature sensor error.
E2-Evaporator temperature sensor error.
E3-Condenser temperature sensorerror
(on some models).
P1-Bottom tray is full--Connect the drain hose
and drain the collected water away. If
protection repeats,call for service.
E4-Display panel communication error.
Fan/Ion button
Control the fan speed. Press to select the fan
speed in four steps-LOW, MED(On some
models), HIGH and AUTO. The corresponding
fan speed indicator light illuminates except
AUTO speed. When select AUTO fan speed, all
the fan indicator lights turn dark. On some
models, when select AUTO fan speed, all the
fan indicator lights illumiante.
NOTE: Press this button for 3 seconds to
initiate ION feature. The ion generator is
energized and will help to remove pollen and
impurities from the air, and trap them in the
filter. Press it for 3 seconds again to stop the
ION feature.
with the + & - buttons. The timer on/off
indicator light illuminates .
Swing/Wireless(On some models) button
Used to initiate the Auto swing feature.
Press the SWING button can stop the louver
at the desired angle.
Used to initiate the Wireless connection mode.
For the first time to use Wireless function,
press and hold the SWING button for 3
seconds to initiate the Wireless connection
mode. The LED DISPLAY shows 'AP' to indicate
you can set Wireless connection. If connection
(router) is successful within 8 minutes, the unit
will exit Wireless connection mode
automatically and the Wireless indicator
illuminates. If connection is failure within 8
minutes, the unit exits Wireless connection
mode automatically. Under Wireless mode,
you can press the swing and down(-) buttons
at the same time for 3 seconds to turn off the
Wireless and the LED DISPLAY shows 'OF' for
3 seconds , press the swing and up(+) buttons
at the same time to turn on Wireless and the
LED DISPLAY shows 'O
' for 3 seconds.
NOTE: When you restart the Wireless function,
it may take a period of time to connect to the
network automatically.
n
Loading ...
Loading ...
Loading ...