Loading ...
Loading ...
Loading ...
12
USER INSTRUCTIONS
EN
12
f fo gnihct iw S 8.2.2
eh t dna peeb t r ohs a s t ime r ehsawhs i d eh t ,ma r go r p eh t f o dne eh t t A
indi-
cator lights of the fourth and fi fth program (ref. pr. 4, pr. 5 fi g. 2-04) fl ash.
Turn off the appliance by opening the door and pressing the on/off button (ref.
1 fi g. 2-02).
FIG. 2-04
If it is necessary to open the door during the washing cycle, the
program will be interrupted, the relative indicator light will continue to
fl ash and a beep will indicate that the cycle has not terminated. Wait
for about 1 minute before closing the door and continuing with the
program. When the door closes, the program will start from where it
was interrupted. This operation should be performed only if neces-
sary as it could cause irregular program performance.
SEHS I D EHT G N I V OM E R 4
˜˜˜
t sae l t a t i aw ,m a r go r p gn i hsaw eh t f o dne eh t t A
20 minute before
removing the dishes in order to allow them to cool. To prevent any
water droplets on the upper rack from falling onto the dishes in the
lower rack, empty the lower rack fi rst and then the upper one.
2.2.9
symbols programs according to the models
(on some models only)
If the option is not provided, we recommend the use of conventional products
(separate detergent, salt and rinse aid), because with conventional washing cycles,
combined products might create problems such as a white deposit, poor drying
results and residues left on dishes.
For further information, refer to the detergent pack.
IMPORTANT:
when no longer required, the option must be deactivated by pressing the relative
button (the light goes out).
These products are not suitable for use with excessively “hard” water. If the
hardness level set is higher than H3, when the option is activated the rela-
tive light ashes to indicate that the product is being used incorrectly; the
dishwasher will still work, but washing results may be poor.
end
Auto
Loading ...
Loading ...
Loading ...