Loading ...
Loading ...
Loading ...
10
Operation
The Very First Time You Grill
Perform an Initial Burn-Off
Heat the grill on the highest setting, with the lid closed,
for at least 20 minutes prior to grilling for the firsttime.
Every Time You Grill
Meal-to-Meal Maintenance
The Meal-To-Meal Maintenance plan includes the
following simple, yet important, steps that should
always be performed prior to grilling.
Check for Grease
Your grill was built with a grease management
system that funnels grease away from food and into a
disposable container. As you cook, grease is channeled
down the slide-out grease tray and into a disposable
drip tray that lines the catch pan. This system should be
cleaned each and every time you grill to preventfires.
1. Confirm that the grill is o and cool.
2. Open the doors.
3. Access the slide-out grease tray by pulling the tray
towards you until it stops (A). Remove excess grease
with a plastic scraper. Scrape the grease down
through the openning in the grease tray, into the
catch pan below.
4. Remove the catch pan (B). Check for excessive
amounts of grease in the disposable drip pan that
lines the catch pan. Discard disposable drip pan
when necessary and replace with a new one.
5. Reinstall all components.
Inspect the Hose
Routine inspection of the hose is necessary.
1. Confirm that the grill is o and cool.
2. Check hose for any signs of cracking, abrasions, or
cuts(C). If the hose is found to be damaged in any
way, do not use the grill.
Check the Power Cord
Routine inspection of the power cord is necessary.
1. Confirm that the grill is o and cool.
2. Check the power cord for any signs of cuts or
damage. If the power cord is found to be damaged in
any way, do not use the grill.
3. Plug the short power cord into the port beneath
the side table, then to the extension cord (D) before
plugging it into a grounded electrical outlet.
4. Turn on the main power switch (E).
Preheat the Grill
Preheating the grill is critical to successful grilling.
Preheating helps to prevent food from sticking to the
grate and gets the grate hot enough to sear properly.
Italso burns o residue of a previously cooked meal.
1. Open the grill lid.
2. Ignite your grill according to the ignition instructions
in this Owner's Manual.
3. Close lid.
4. Preheat the grill with all burners on the start/high
position for 15 minutes(F).
Clean the Cooking Grate
After preheating, any bits of food or debris left over from
previous use will be easier to remove. Cleaned grates
will also prevent your next meal from sticking.
1. Brush the grates with a stainless steel bristle grill
brush immediately after preheating (G).
m DANGER: Do not line the slide-out grease tray
or cookbox with aluminum foil.
m DANGER: Check the slide-out grease tray and
catch pan for grease build-up before each use.
Remove excess grease to avoid a grease fire.
m WARNING: Use caution when removing catch
pan and disposing of hot grease.
m WARNING: Use heat-resistant barbecue mitts
or gloves when operating grill.
m WARNING: Grill brushes should be checked for
loose bristles and excessive wear on a regular
basis. Replace brush if any loose bristles are
found on cooking grates or brush. WEBER
recommends purchasing a new stainless steel
bristle grill brush at the beginning of every
spring.
m WARNING: If the hose is found to be damaged
in any way, do not use the grill. Replace using
only WEBER authorized replacement hose.
m WARNING: Keep ventilation openings around
tank clear and free of debris.
m WARNING: Keep any electrical supply cord
and the fuel supply cord away from heated
surfaces.
C
F
G
A
B
E
D
Loading ...
Loading ...
Loading ...