Loading ...
Loading ...
Loading ...
Additional information
6
6
37
2
34
4
Wall-mounting the front and surround speaker
system
Attaching the brackets
•
When attaching the speakers to brackets, always use the
furnished brackets for wall mounting.
•
Make sure to tighten the supplied screw as securely as
possible when attaching the bracket to the back of the
speaker.
•
Do not attach brackets to center speaker or subwoofer.
CAUTION
•
Use the M5 metric thread screw. Do not use inch thread
screw.
Before mounting
•
Remember that the speaker system is heavy and that its
weight could cause the wood screws to work loose, or the
wall material to fail to support it, resulting in the speaker
falling. Make sure that the wall on which you intend to
mount the speakers is strong enough to support them. Do
not mount on plywood or soft surface walls.
•
Mounting screws are not supplied. Use screws suitable for
the wall material and support the weight of the speaker. If
you are unsure of the qualities and strength of the walls,
consult a professional for advice.
Resetting the main unit
Use this procedure to reset all the receiver’s settings to the
factory default. Use the front panel controls to do this.
1
Switch the receiver into standby.
2
While holding down
BAND
, press and hold
Í
STANDBY/ON
for about two seconds.
3
When you see RESET? appear in the display, press
AUTO SURROUND/STREAM DIRECT
.
OK? shows in the display.
4
Press
ALC/STANDARD SURR
to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
Important
•
If the Standby Through is not set to OFF, you may not be
able to initialize the unit.
Cleaning the unit
•
Use a polishing cloth or dry cloth to wipe off dust and dirt.
•
When the surface is dirty, wipe with a soft cloth dipped in
some neutral cleanser diluted five or six times with water,
and wrung out well, and then wipe again with a dry cloth.
Do not use furniture wax or cleansers.
•
Never use thinners, benzine, insecticide sprays or other
chemicals on or near this unit, since these will corrode the
surface.
Screw (supplied)
5 mm to 7 mm (
3
/16 in. to
9
/32 in.)
Mounting screw (not supplied)
5 mm
(
3
/16 in.)
10 mm
(
7
/16 in.)
HTP-074_En.book 37 ページ ２０１６年４月８日 金曜日 午後６時４５分
Loading ...
Loading ...
Loading ...