Loading ...
Loading ...
Loading ...
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
SE NG THE CLOCK
[] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] [] []
The _£_) or (.J_} pad is used to set the chock. The chock may be set for 12 or 24 hour time of
day operation. The chock has been preset at the factory for the 12 hour operation. When the
range is first plugged in, or when the power supply to the range has been interrupted, the
timer in the display wiil flash with "PF" (power failure, See Figure 1). Note: The chock
cannot be set when the oven is on.
When PF appears in the display, press (_)_A,0,or _. No sound wiil be heard, but after 10
seconds a beep wiil sounds and PF wiil disappear.
To set the clock (example below for 1:30):
1. Press 0 or _. "CLO" wiil appear in the display (Figure 2).
2. Press Q (_) Q pads to set the time of day to 1:30 <Figure 3). "CLO" wiil
appear in the display. Press (_) or _. "CLO" wiil disappear and the chock wiil
start (Figure 4).
Changing between 12 or 24 hour time of day display:
1. Press and hold _ or _Q.,_for 8 seconds (Figure 3). While holding the
pad
down the current time of day wiil remain and "CLO" wiil disappear from the
display (Figure 4). CONTINUE holding the pad until a beep is heard.
2. The display wiil show either "12Hc" (Figure 5) or "24Hr" (Fig.6).
3. Press _ or _,} to switch between the 12 and 24 hour time of
day display.
The display wiil show either "12Hc" (Figure 5) or "24Hr" (Figure 6).
or (_,)to accept the change or press _ or _ to reject
4. Press the
change.
5. Reset the correct time as described in To set the Clock above. Please note
that if the 24 hour time of day mode was chosen, the chock wiil now display
time from 0:00 through 23:59 hours.
Loading ...
Loading ...
Loading ...