Loading ...
Loading ...
Loading ...
49-50336 Rev. 0 9
CARE AND CLEANING
Anode Rod Maintenance and Service
Tools needed:
• Flat Head Screwdriver
• Socket/Torque Wrench
• 1
1
/16” Socket
• Pipe Joint Compound or Pipe Thread Sealant Tape
• Anode Rod, if needed
* See page 18 for part ordering instructions
To service the Anode Rod:
1. Disconnect power, shut off the water supply, drain the
water lines of the home. Drain one or two gallons from
the water heater through the lower drain valve.
2. Remove anode cap and foam insulation in hole with
flat head screwdriver to expose anode fitting as shown
in Illustration A.
3. Using a 1
1
/16” socket, unscrew the anode rod, then lift
out to inspect as shown in Illustration B.
4. Inspect and replace if necessary.
5. To install the anode rod, seal the threads with pipe
joint compound or pipe thread sealant tape, thread
into the port and using the torque wrench tighten to 50
± 5 ft-lbs of torque.
6. Turn water supply on, open a tap to remove any air
in plumbing system, inspect for leaks, then replace
anode cap and turn the power on.
CAUTION - IMPORTANT SAFETY NOTICE
This information is intended for use by individuals
possessing adequate background of electrical,
electronic and mechanical experience. Any attempt
to repair a major appliance may result in personal
injury and property damage. The manufacturer or
seller cannot be responsible for the interpretation
of this information, nor can it assume any liability in
connection with its use.
Illustration A
Illustration B
Replace Anode Rod if
more than 6” of core wire
is exposed.
Loading ...
Loading ...
Loading ...