Loading ...
Loading ...
Loading ...
14 49-1000492 Rev. 3
Installation Instructions
INSTALLING THE WINE CENTER (Cont.)
Remove all protective film from the door before
installing the handle.
HANDLE INSTALLATION
1. Remove the handle allen wrench from the
accessory bag located inside the wine center.
2. Remove the handles from the top piece of the
packaging material.
3. Loosen the set screw using the allen wrench.
Place the handle caps over the fasteners of the
door, so that the Cafe badge is at the top of the
handle. Take care to support the handle so it doesn’t
fall and scratch the appliance finish. Make sure both
handle caps are resting on the face of the door.
4. Lock one end of the handle into position by
tightening the set screw in the handle cap with the
allen wrench provided. DO NOT over-tighten.
.HHSVXSSRUWLQJWKHKDQGOHDV\RXORFNWKHRWKHU
end of the handle into position by tightening the set
screw in the handle cap. DO NOT over-tighten.
DOOR ADJUSTMENT
1. Peel back the gasket near the hinge
2. Use a flat screwdriver to remove the plastic cover.
3. Loosen the screws to make the adjustment and the
tighten the screw. NOTE: Push door in direction of
arrow to raise handle side of door.r
4. Re-install the plastic cover and gasket. Make sure
that gasket is fully seated in the pocket.
LOOSEN
set screw
set screw
fastener
handle cap
set screw
set screw
Gasket
INSTALLATION INSTRUCTIONS
Loading ...
Loading ...
Loading ...