Loading ...
Loading ...
Loading ...
Method 1: Install the duct(s) from the outside of the home down to the location of the exhaust
outlet(s) on the top of the hood allowing room for the transition (if applicable). If a
transition is used, install duct down to the location of the transition outlet plus 1”.
This will allow the transition to engage 1” inside of duct.
Method 2: Install the duct(s) from the outside of the home to the ceiling over the exhaust
outlet(s) on the hood. The end of the duct(s) should extend 1” below the ceiling.
Use foil HVAC tape (not grey cloth duct tape) to seal all joints. A complete listing of available
Hestan ducting materials is provided on the back page of this instruction sheet.
TRANSITION HEIGHTS:
Dual Blower (WM2L, 600 CFM): none - 8” round duct will connect directly to the top of the
hood.
Single and Dual Blower (WM1L + WM2L, 900 CFM): 6” round duct will connect directly to the
top of the hood; 8” round will connect directly to the top of the hood.
Or use optional multi-blower transition (AKVT6810, sold separately). See “Vent
Accessories” on page17 for details.
Two Dual Blowers (Two WM2Ls, 1200 CFM):
Two 8” round ducts connect directly to the top of the hood.
Or use optional multi-blower transition (AKVT6812, sold separately). See “Vent
Accessories” on page17 for details.
CONNECTION DIAGRAMS
Motor
Cooling
Vent
Electrical
WM2L Dual Blower (600 CFM ) (Top View)
Wall side
Centerline
of hood
Connection diagram (30-36” width)
8" [20.3 cm] round
5 1/2"
[14 cm]
1 3/4"
[4.4 cm]
5 1/4"
[13.3 cm]
8" Round
Connection Diagram (42” Width)
WM2L Dual + WM1L Single Blower (900 CFM) (Top View)
Wall side
Centerline
of hood
Electrical (2)
Motor
Cooling
Vent (3)
6" [15.2 cm]
round
7 5/16"
[18.6 cm]
1 7/8"
[4.8 cm]
5 1/4"
[13.3 cm]
1 3/4"
[4.4 cm]
7 5/16"
[18.6 cm]
5 1/2"
[14 cm]
INSTALLATION
(CONT.)
©2018 Hestan Commercial Corporation
12
EN
Loading ...
Loading ...
Loading ...