Loading ...
Loading ...
Loading ...
Aboutthe temperaturecontrols. GEAppliances.com
j-
The temperature controls are preset in the factory at 37°1:for the
refrigerator compartment and O°Ffor the freezer compartment. Allow
24 hours for the temperature to stabilize to the preset recommended
settings.
The temperature controls can display both the SET temperature
as well as the actual temperature in the refrigerator and freezer.
The actual temperature may vary slightly from the SET temperature
based on usage and operating environment.
Setting either or both controls to OFFstops cooling in both the freezer
and refrigerator compartments, but does not shut off electrical power
to the refrigerator.
NOTE: The refrigerator is shipped with protective film covering the
temperature controls. If this film was not removed during installation,
remove it now.
Tochange the temperature, press and release the
WARMER or COLDERpad. Tile SETlight will come
on and tile display will show tile set temI)eratm'e.
To change tile temperatm'e, tap either tile
WARMER or COLDERpad until tile desired
temperatm'e is displayed. Refl'igerator temperatm'es
can be ac!justed between 34°F and 44°F and tile
fl'eezer temperatm'es can be ac!iusted between
-6°F and +6°E
Once tile desired temperature has been set,
tile temperatm'e display will retm'n to tile actual
refl-igerator and fl'eezer temperatm'es after 5
seconds. Several ac!iusnnents may be required.
Each time you a(!itlSt controls, allow 24 hotli's t0I" tile
refl-igerator to reach tile temperatm'e you have set.
Toturn the cooling system off,tap tile WARMER pad
for either tile refl-igerator or tile fl'eezer tmtil tile
display shows OFF. To turn the unit back on, press tile
COLDERpad fin" either tile refrigerator or fl'eeze_:
The SETlight will illuminate on the side w)u
selected. Then press the COLDERpad again (on the
side where the SErlight is illuminated) and it will
go to tile preset points of O°Ftor tile fl'eezer and
37°ElOr tile refl-igerato_: Setting either or both
controls to OFFstops cooling in both the fl'eezer
and refrigerator compartments, but does not shut
off electrical power to tile refl-igerato_:
PerformanceAk FlowSystem
Tile Perl0mmnce M>Flow System is designed to
maximize temperature control in tile refrigerator
and fl'eezer comparmlents. This unique special
teatm'e consists _ff tile Mr Tower along tile back
wall of tile refrigerator and tile Mr Tmmel on tile
bottom portion of tile fl'eezer rear wall. Placing fi_od
in fl'ont ot tile louvers on these components will not
affect pe_fommnce. Mthough tile Mr Tower and
tile ?dr Tmmel can be removed, doing so will affect
temperatm'e pedomlance. (For removal
instructions, on-line, 24 horn's a da> contact us at
GEAl)pliances.com or call 800.GE.CARES. In
Canada, contact us at geappliances.ca or call
1.800.361.3400.)
Loading ...
Loading ...
Loading ...