Loading ...
Loading ...
Loading ...
15
Assembly, Operation & Maintenance Instructions
STEP 04
Take the two bottom shelf supports (06.07) and t them onto the cylindrical tabs at the
inside of each foot. Rotate each one so that the outmost screw holes are facing inwards
and the inner screw holes are facing the stand top (if not, pull out and t in the opposite
way). Take the two upper shelf supports (13.14) and t them onto the legs (03.04.05.06).
Fix the bottom shelf support L (06) in place with two M6x0.5in (12mm) screws (A). Fix
the bottom shelf support R (07) in place with two M6x1in (28mm) screws (j) and at
washers (E). When all are assembled, tighten up all four screws and the screws from step
03.
STEP 05
/ Turn the stand onto its legs and check that all of the legs are stable. Take the plastic bottom
shelf (16) and place it on the two bottom shelf supports. Line the four holes in the bottom
shelf up with the threaded holes in the bottom tray supports and x into position using four
M5x0.5in (12mm) screws (B) and four spring washers (C). Tighten fully. Take the plastic
upper shelf (17) and place it on the two upper shelf supports. Line the four holes in the upper
shelf up with the threaded holes in the upper tray supports and x into position using four
M5x0.5in (12mm) screws (B) and four spring washers (C). Tighten fully.
STEP 06
/ Take the cylinder belt (I) and x into place using two M5x0.6in (15mm) screw (F). The gas
cylinder can be put onto the bottom shelf support R (07) and x in place by cylinder belt (I).
Tighten it by adjusting the cylinder belt (I).
J
E
Loading ...
Loading ...
Loading ...