Loading ...
Loading ...
Loading ...
SW12-RESET SW4-INSTALL SW9-LINK
SW12
-
RESET SW4
-
INSTALL SW9
-
LINK
PB1-NETWORK
PB1-NETWORK
PB1–NETWORK
Used to uninstall the thermostat
from receiver(s) it has been
linked to.
SW12–RESET
Master Reset – Returns thermostat
to all factory defaults.
SW4–INSTALL
Starts an installation session.
SW9–LINK
Used to link the thermostat to
control receiver(s).
Node
Good
Please Wait
Install
HEAT
COOL
NOTE: The display always blinks
the item that is active and can
be changed.
Linking the thermostat and receiver.
1. Press the SW4-INSTALL button
inside the thermostat. Press the
HEAT/COOL button on the front
of the thermostat to select your
choice. Press the UP button to set
the receiver number (0–7) and
press the HEAT/COOL button
to set the receiver.
2. Press the SW9-LINK button
inside the thermostat.
Within 5 seconds, press the
RESET/LINK button (PB3)
on the receiver. “Good” will
appear if linked. “Bad” will
appear if not linked.
3. Press the SW4-INSTALL
button to complete the
installation session.
Thermostat Internal Buttons
Display
PB3-RESET/LINK
PB3-RESET/LINK
Receiver Internal Button
Removing or Delinking a Receiver
Unlike installing a receiver, the procedure to remove or “delink” a receiver will uninstall all
receivers installed to the thermostat at once. You cannot remove a single receiver at a time.
1. Press the SW4-INSTALL button inside the thermostat. The ”Install“ icon will flash. Press the UP
button to get the “Remove” choice and press the HEAT/COOL button to select. The “Heat”
and “Cool” icons will be displayed and all display items will be on steady; nothing will be
flashing.
2. Press the SW9-LINK button on the back of the thermostat printed circuit board. Within
5 seconds, press the PB3 RESET/LINK button on the receiver. When the SW9-LINK button
is pressed, the thermostat will display the “Please Wait” message in the bottom right corner
of the LCD while it searches for a receiver. Once the thermostat finds its installed receiver(s),
linking information is removed from the receivers and the thermostat, the “Please Wait”
message is extinguished and a “Good” message will appear.
3. To complete the process, press the SW4-INSTALL button.
7
Loading ...
Loading ...
Loading ...