Loading ...
Loading ...
Loading ...
CLEANING VARIOUS PARTS OF YOUR RANGE
Before cleaning any part of the range, be sure all controls are turned OFF and the range is COOL. REMOVESPILLOVERSAND
HEAVY SOILING AS SOON AS POSSIBLE. REGULARCLEANING WILL REDUCE THE NUMBER OF MAJOR CLEANING LATER.
• Aluminum & Vinyl Use hot, soapy water and a cloth. Dry with a clean cloth.
® Painted and plastic control Using as0ft cloth; clean with mild dish detergent and Water or a 50/50 solution Of
Vinegar and water. Follow by rinsing the area with Ctean Water; dry and p0tish with
• Painted body parts a soft cloth, Glass cleaners may be used if sprayed on a soft cloth first. DO NOT
• Painted decorative trims spray qu ds d recty on the contro pad and d sp ay area: Do not use argo amounts
of water on the contro! panel _ excess water on the c0ntrol area may cause damage
to the appliance: DOnot use other liquid cleaners;abrasive cleaners, scour ng pads;
or paper towels _they W II damage the fin sh, To remove c0ntrol kn0bs; turn tothe
OFF p0siti0n;grasp firmly and pull straight Off the shaft. To replace knobs after
cleaning, line up the flat sides of both the knob and the shaft; then push the knob
into place:
• EasyCare TM Stainless Steel Your range finish is may be made with Easy Care TM Stainless Steel (some models).
Clean the stainless with warm soapy water using a clean sponge or cloth. Rinse
with clean water and dry with a soft clean cloth. DO NOT use ANY store bought
cleaners like Stainless Steel cleaners or any other types of cleaners containing any
abrasive, chlorides, chlorines or ammonia. It is recommended to use mild dish soap
and water or a 50/50 solution of water and vinegar.
Porcelain enamel Gentle Scouring With a soapy scouring pad wit! remove m0st
pan and insert(availab!e by l:$sotution of dear water and ammonia, If necessary, cove r difficult sPots with an
mail order)ammonia-soaked paper towel for 30 to 40 minutes, Rinse with clean water and a
• Door liner & body parts damp cloth, and then scrub with a soap,filled scour ng pad, Rinse and wipe dry with
a dean cloth: Remove all cleaners 0r the p0rcelain may become damaged during
future heating. DO NOT use spray oven cleaners on the cooktop.
• Oven racks Oven racks must be removed from oven cavity, Clean by using a mild, abrasive
cleaner following manufacturer's instructions. Rinse with clean water and dry.
• Oven door use soaP & Water to thoroughly clean the top; Sides and front of the oVen do0r. Rinse
well, You may use a glass cleaner on the outside glass of the door. Do not immerse
the door in Water. Do not spray or allow water or the glass cleaner to enter
: the door vents, Do not use oven cleaners, cleaning powders orany harsh abrasive
cleaning materials onthe outside of the oven door.
Do not Cleanthe oven door gasket' on self-dean m0deis; the oven do0r gasket is
made of a woven material wh !Ch is essential for agood seaL ca re sh0uld be ta ken
not to rub, damage or remove this gasket.
TO REMOVE THE "HIDDEN BAKE" COVER (some models)
1. In order to remove the "hidden bake" cover, pull the back edge with one hand
about 1/2inch and lift up the "hidden bake" cover with both hands. (See picture)
2. When re-installing the "hidden bake" cover, be sure to put it all the way to the
back of the oven and lay it down on the 2 shoulder screws. Then push the front
edge of the cover in its place below the front bracket.
To have easier access to the "hidden bake" cover, you can remove the oven door by
following the instructions on previous page.
Always replace the "hidden bake" cover before the next use.
Loading ...
Loading ...
Loading ...