Loading ...
Loading ...
Loading ...
REPLACINGTHELINE
1. Removethespoolbyfirmlypulling
onthetapbutton.
2. Cleanentire surface of hub and
spool.
3. Replace with a pre-wound spool
(C944.510210), or cut a length of
30 feet of 0.065" (1.65 mm) diame-
ter Craftsman _>Pro Trimmer line.
Use of heavier lines could over-
load and damage unit.
_.WARNING: Never use wire,
rope, string, etc., which can break off
and become a dangerous missile.
4. Insert one end of the line about 1/2
inch (1 cm) into the small hole in-
side the spool.
5. Wind the line evenly and tightly
onto the spool. Wind in the direc-
tion of the arrow found on the
spool.
6. Push the line into the notch, leav-
ing 3 to 5 inches (7 - 12 cm) un-
wound.
7. Insert the line into the exit hole in
the hub as shown in the illustration.
8. Align the notch with the line exit
hole.
9. Push the spool into the hub until it
snaps into place.
10. Pull on the line extending outside
the hub to release it from the
notch; otherwise, the unit will not
function properly.
Small
Hole_ 4_//,/'(',.i_"_'_.{
,-';_'o,',iV_XY','¢_"- spool
1,_";'_L0/II
Tap/- 'tLzY
Button _,_,v
Line in Notch
Hub
Line exit hole
USER REPLACEABLE SERVICE PARTS
REPLACEMENT PART
Spool with 0.065 in. Trimmer Line
Assist Handle
Bolt Carriage, 1/4-20
Wing Nut
Shield Assembly
Edge Guide
PART NUMBER
C944.510210
530403805
530403886
530016118
530403915
530403845
z_
llWARNING: Perform the follow-
ing steps after each use.
• Stop the unit and disconnect the
power source when not in use.
• Carry the unit with motor stopped.
• Store the unit so the line limiter
blade cannot cause injury.
• Store unit and extension cord in-
doors in a high, dry place out of the
reach of children. Store unit un-
plugged.
• Store unit with all guards in place.
Position unit so that any sharp ob-
ject cannot accidentally cause injury.
Loading ...
Loading ...
Loading ...