Loading ...
Loading ...
Loading ...
TROUBLESHOOTING TABLE
_WARNING: Always stop unit and disconnect from tile power source before
performing all of the recommended remedies below except remedies that re-
quire unit to be operating.
TROUBLE CAUSE REMEDY
Trimmer head 1. Crowding trimmer line 1. Allow tip of line to do the cutting.
stops under a against material being
load or does not cut.
turn when switch 2. Electrical failure. 2. Contact your Sears Service Centre.
is pressed. 3. Thrown circuit breaker. 3. Check Breaker Box.
4. Debris stopping head. 4. Remove debris.
Line does not 1. Une improperly routed 1. Check line routing.
advance or in head.
breaks while 2. Une improperly 2. Rewind line tightly and evenly.
cutting, wound into spool.
3. Incorrect line size 3. Use only 0.065 in. (1.65 ram) dia. line.
4. Not enough line 4. Remove cover and pull 4 in.
outside of head. (10 cm) of line out of head.
5. Dirt buildup on unit. 5. Clean unit.
Line welds onto 1. Line size is incorrect. 1. Use only 0.065 in. (1.65 mm) dia. line.
spool. 2. Incorrect spool. 2. Replace with correct spool.
3. Line is being crowded 3. Cut with tip of line fully extended.
against material being
cut.
Line releases 1. Line improperly 1. Check line routing.
continuously, routed in head.
2. Spool damaged. 2. Replace spool.
Line usage is 1. Line improperly routed 1. Check line routing.
excessive, in head.
2. Line size is incorrect. 2. Replace spool.
3. Crowding line against 3. Cut with tip of line fully extended.
material being cut.
4. Spool worn or damaged. 4. Replace spool.
Line pulls back 1. Too little line outside 1. Remove cover and pull 4 inches
into head. of head. (10 cm) of line outside of head.
2. Line size incorrect. 2. Use only 0.065 in. (1.65 mm) dia. line.
10
Loading ...
Loading ...
Loading ...